7601 EVERGREEN WAY US BANK 2019-09-05

Interior Lighting - Building Area Method LTG-INT-BLD 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised July 2016 Project Title: Fill this line out on LGT-SUM Date 7/1/2016 Calculation 0 O Addition- O Addition For Building Department Use Area NOTE$ stand alone +existing o Spaces where<50%of O Spaces where>_50%of O luminaires are replaced luminaires are replaced LPA ® Standard O Additional Efficiency Package Option 0 Calculation C406.3 Reduced Interior Lighting Power To comply with C406.3,the Proposed LPD shall be 25%lower than the Target LPA. Type Refer to C406.3 for additional requirements. Maximum Allowed Lighting WattageNOTE 1 Location(plan#, Gross Interior Allowed Watts Allowed Building Area room#,or ALL) Area Description Area in ft2 Watts per ft2 (watts/ft2 x area) Retail ALL US In-Store Bank 641 1.01 648 Total 641 Proposed Lighting Wattage Location(plan#, Number of Watts per Building Area room#) Fixture Description NOTE 2,3,4,5 Fixtures Fixture NOTE 6 Watts Proposed Retail 2ft x 2ft Recessed LED Luminaire 16 22 352 Retail 4W.Mini LED Pendant Luminaire 4 4 16 Retail 33"LED Undercabinet Luminaire 4 14 54 Compliance by Building Area NOTE 7 Total Allowed Total Proposed Interior Lighting Building Area Warnings Watts Watts Power Allowance Retail 648 422 COMPLIES Note 1-List all unique building areas per Table C405.4.2(1)that occur in the Totals 648 422 project scope.Select building area category from drop down menu. Note 2-Proposed fixtures must be listed in the building area in which they occur.List all proposed lighting fixtures including exempt lighting equipment and existing-to-remain fixtures. Note 3-For proposed Fixture Description,indicate fixture type,lamp type(e.g. T-8),number of lamps in the fixture,and ballast type(if included). For track lighting,list the length of the track(in feet)in addition to the fixture,lamp,and ballast information. Note 4-For lighting equipment eligible for exemption per C405.4.1,note exception number and leave Watts/Fixture blank. Note 5-Existing-to-remain fixtures shall be included in the Proposed Lighting Wattage table in the same manner as new fixtures.Identify as existing in fixture description. Note 6-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage).For low voltage lighting,enter the wattage of the transformer.For line voltage track/busway systems,enter the larger of the attached luminaire wattage or 50 watts/lineal foot,or enter the wattage limit of permanent current limiting device.