Laserfiche WebLink
Intertek Testing Services NA Inc. <br /> AUTHORIZATION TO MARK <br /> This authorizes the application of the Certification Marks shown below to the Product Covered(also to the multiple listee model identified on <br /> the correlation page of the Listing Report where applicable)when made in accordance with the Description and under the conditions set forth in <br /> the Certification Agreement and Listing Report: <br /> Applicant: Garmat USA Inc. Manufacturer: Same as Applicant <br /> 1401 W.Stanford Ave <br /> Englewood,CO 80110 <br /> Contact: John Jurasic(303)781—6802,Fax(303)781 -2683 <br /> Party Authorized To Apply Mark: Same as Applicant <br /> Reference Report No.: 3054850-003 <br /> Report Issuing Office: Cortland HVAC,3933 US Rt. 11,Cortland NY, 13045 <br /> Product Covered: Products covered are direct fired heaters,model numbers—42010,42010X,42106,42106X, <br /> 46008,46008X,48106,48106X <br /> Description: The product covered by this report is a paint spray booth that has a ventilation system <br /> interlocked to the spray application equipment.The paint spray booth incorporates a natural <br /> gas.Direct Gas Fired Heater that is an integral part of the paint spray booth cabin.The product <br /> is provided with a Listed Industrial Control Panel,and Listed Electric Lighting Fixtures for <br /> Use in Hazardous Locations.The paint spray booth is fully automated with Spray and Bake <br /> Cycles of operation.The paint spray booth is permanently connected to the electrical supply <br /> source.The heater pre-conditions the incoming air to a maximum of 2000 F.and is connected <br /> through permanently installed ducting.The exhaust ventilation is also connected through <br /> permanently installed ducting to a safe discharge location. <br /> • Fuels—Natural Gas. <br /> • Unit Configuration—Down Flow,Blow Through <br /> • Discharge Configuration—Horizontal <br /> • Clearances to Combustible Material—4"from top,sides and ends.(For service <br /> clearances,the distance of the door opened to 90 degrees is used.) <br /> • For installation on Combustible Surfaces. <br /> Standard(s): Non-Recirculating Direct Gas-Fired Industrial Air Heaters <br /> ANSI Z83.4-1999•CSA 3.7-M99(Revisions through 10/01/99 w/Addenda A—2001,and <br /> Addenda B-2002) <br /> This procedure,with all revisions,etc.,is the property of Intertek Testing Services and is intended solely for the guidance of the <br /> listee and the representative of Intertek Testing Services,and is not transferable. <br /> Issued by: Intertek Testing Services NA Inc. <br /> 165 Main Street cauS <br /> Cortland,NY 13045-2014 USA <br /> Authorized by: Date:;:� �Q;'/,ce,/)r t2 :7 r. <br /> William T.Starr <br /> Certification Manager <br /> 4 Control Number: <br /> //A?' - <br />