4114 HOYT AVE 2019-09-23 - Laserfiche WebLink

Intertek Testing Services NA Inc. Report No.3054850-003 Page 7 Issued:4/26/04 Garmat USA Inc. GENERAL REQUIREMENTS AND DEFINITIONS Recognized-Identifies any component,part or subassembly covered under the recognition service of an NRTL(US)or a CO (Canada)and intended for use in ETL Listed,ETL Classified,or ETL Recognized products. Listed-Identifies any product covered under the Listing or Certification service of an NRTL(US)or a CO(Canada). Construction Details-For specific construction details,reference should be made to the following photographs and descriptions. All dimensions are approximate unless specified as exact or within a tolerance. In addition to the specific construction details described in this Report,the following general requirements also apply. 1. Spacings-In primary circuits,the following spacings are maintained through air and over surfaces of insulating material between current-carrying parts of opposite polarity and between current-carrying parts and dead-metal parts. MINIMUM SPACING mm(in) RATINGS THROUGH AIR OVER SURFACE TO ENCLOSURE VA VOLTS mm in mm in mm in 0-2000 0-300 3.2 1/8 6.3 'A 6.3 1/4 More 0-150 3.2 1/8 6.3 'A 12.5 Than 2000 151-300 6.3 1/4 9.5 3/8 12.5 /z 301-750 9.5 3/8 12.5 /2 12.5 %z 2. Mechanical Assembly-Components such as switches,fuseholders,connectors,wiring terminals and display lamps are reliably mounted and prevented from shifting or rotating by lockwashers,starwashers,or the mounting format. 3. Corrosion Protection-All ferrous metal parts are suitably protected against corrosion by painting,plating or the equivalent. 4. Grounding-All exposed dead-metal parts and all dead-metal parts within the enclosure that are exposed to contact during any servicing operation and that are likely to become energized are reliably connected to the equipment ground connector. 5. Current Carrying Parts-All current-carrying parts in primary circuitry are silver,copper,or copper based alloy.