1310 SE EVERETT MALL WAY Geotech Report 2022-10-25

2006 Wa ton State Nonresidential Energ Code Comp� e Form � • • ' • 2006 Washington State Nonresidential Energy Code Compliance Forms Revised July 2007 Project Address sE Everett r�ii way, Everett, wr. Date 4/4/2013 The�ollowin�information js neGes ary to�heck a building permit application for compliance with the building envelope requirements in the Was ington tate Nonresidential�nergy ode. Applicability Code Location Building Department (yes, no, n.a.) Section Component Information Required on Plans Notes GENERAL REQUIREMENTS (Sections 1301-1314) 1301 Sco e Unconditioned s aces identified on lans if allowed yes 1302 Space heat type: Other If"Other', AC-1 indicate on lans that electric resistance heat is not allowed 1310.2 Semi-heated spaces Semi-heated spaces identified on plans if allowed 1311 Insulation yes 1311.1 Insul.installation Indicate densities and clearances yes 1311.2 Roof/ceiling insul. Indicate R-value on roof sections for attics and other roofs; A-6/3 Indicate clearances for attic insulation; Indicate baffles if eave vents installed. Indicate face sta lin of faced batts yes 1311.3 Wall insulation Indicate R-value on wall sections; A-6/3 Indicate face stapling of faced batts; Indicate above grade exterior insulation is protected; Indicate loose-fill core insulation for masonry walls as necess; Indicate heat capacity of masonry walls if mason o tion is used F73 1311.4 Floor insulation Indicate R-value on floor sections; N/A Indicate substantial contact with surface; Indicate supports not more than 24"o.c.; Indicate that insulation does not block airFlow throu h foundation vents no 1311.5 Slab-on-grade floor Indicate R-value on wall section or foundation detail; Indicate slab insulation extends down vertically 24"from top; Indicate above rade exterior insulation is rotected 1311.6 Radiant floor Indicate R-value on wall section or foundation detail; Indicate slab insulation extends down vertically 36"from the top; Indicate above grade exterior insulation is protected; Indicate insulation also under entire slab where re 'd.b Official 1312 Glazing and doors Provide calculation of glazing area(including both vertical vertical and overhead as ercent of ross wall area 1312.1 U-factors Indicate glazing and door U-factors on glazing and door schedule(provide area-weighted calculations as necessary); Indicate if values are NFRC or default,if vatues are default then specify frame type,glazing layers,gapwidth,low-e coatin s as fillin s 1312.2 SHGC&SC Indicate glazing solar heat gain coeffcient or shading coefficient on glazing schedule(provide area-weighted calculations as necessa 1313 Moisture control 1313.1 Vapor retarders Indicate vapor retarders on warm side 1313.2 Roof/ceiling vap.ret. Indicate vapor retarder on roof section; Indicate va .retard.with sealed seams for non-wood struc. 1313.3 Wall vapor retarder Indicate vapor retarder on wall section 1313.4 Floor vapor retarder Indicate vapor retarder on floor section 1313.5 Crawl space vap.ret. Indicate six mil black poiyethylene overlapped 12"on ground 1314 Air leakage 1314.1 Bldg.envel.sealing Indicate sealing,caulking,gasketing,and weatherstripping 1314.2 Glazing/door sealing Indicate weatherstripping 1314.3 Assemb.as ducts Indicate sealing,caulking and gasketing 1314.4 Recessed Lighting Fixtur Indicate IC rating,ASTM E283 certification,and gasketing or caulking to ceiling PRESCRIPTIVE/COMPONENT PERFORMANCE (Sections 1320-23 or 1330-34) Envelope Sum Form Completed and attached. Provide component performance worksheet if necessary If"no"is shown for any question, provide explanation: / / � � /� ��