Laserfiche WebLink
I <br /> 1 nuts may not be used for any purpose. All external electrical connections to the luminaire <br /> 2 shall be made through the terminal block. <br /> 3 <br /> 4 LED luminaires shall include a 7-pin NEMA photocell receptacle. The LED driver(s) shall <br /> I 5 be dimmable from ten volts to zero volts. LED output shall have a Correlated Color <br /> 6 Temperature (CCT) of 4000K nominal (4000-4300K) and a Color Rendering Index (CRI) <br /> 7 of 70 or greater. LED output shall be a minimum of 85% at 75,000 hours at 25 degrees <br /> 8 Celsius. <br /> 9 <br /> 10 LED luminaires shall be available for 120V, 240V, and 480V supply voltages. Voltages <br /> 11 refer to the supply voltages to the luminaires present in the field. LED power usage shall <br /> 12 not exceed the following maximum values for the applicable wattage class: <br /> 13 <br /> Class I Max. Wattage 1 <br /> I 200W 110W <br /> 250W 165W <br /> ' 310W 210W <br /> 400W i1 <br /> 275W <br /> 14 <br /> 15 Only one brand of LED conventional roadway luminaire may be used on a Contract. They <br /> I 16 do not necessarily have to be the same brand as any high-mast, underdeck, or wall-mount <br /> 17 luminaires when those types of luminaires are specified in the Contract. LED luminaires <br /> 18 shall include a standard 10 year manufacturer warranty. <br /> 19 <br /> 20 The list of pre-approved LED Conventional Roadway Luminaires is available at <br /> 21 http://www.wsdot.wa.gov/Design/Traffic/ledluminaires.htm. <br /> 22 <br /> I 23 9-29.10(2) Decorative Luminaires <br /> 24 This section, including title, is revised to read: <br /> 25 <br /> I 26 9-29.10(2) Vacant <br /> 27 <br /> 28 9-29.12 Electrical Splice Materials <br /> I 29 This section is supplemented with the following new subsections: <br /> 30 <br /> 31 9-29.12(3) Splice Enclosures <br /> 32 9-29.12(3)A Heat Shrink Splice Enclosure <br /> 33 Heat shrink splice enclosures shall be medium or heavy wall cross-linked polyolefin, <br /> 34 meeting the requirements of AMS-DTL-23053/15, with thermoplastic adhesive <br /> 35 sealant. Heat shrink splices used for "wye" connections require rubber electrical <br /> I 36 mastic tape. <br /> 37 <br /> 38 9-29.12(3)B Molded Splice Enclosure <br /> I 39 Molded splice enclosures shall use epoxy resin in a clear rigid plastic mold. The <br /> 40 material used shall be compatible with the insulation material of the insulated <br /> 41 conductor or cable. The component materials of the resin insulation shall be <br /> 42 packaged ready for convenient mixing without removing from the package. <br /> 1 43 <br /> I <br /> IIICITY OF EVERETT AMENDMENTS <br /> PACIFIC AVENUE TO INTERURBAN TRAIL BICYCLE SAFETY PROJECT 8/12/2019 <br /> STATE FUND#HLP PB17(014); COE#PW3688 Page AM-137 <br />