Kamins Construction Inc Pacific Ave to Interurban Trail Bicycle Safety

I 1 6NTPEP test deck. or a test deck conforming to ASTM D713, shall be conducted for a 111 2 minimum of six months with the following additional requirements: it shall be applied at 15 3 wet mils to a test deck that is located at 40N latitude or higher with at least 10,000 ADT 4 and which was applied during the months of September through November. 5 6 'Paint is applied to an approximately 4"x12" aluminum panel using a drawdown bar with 7 a 50 mil gap. The coated panel is allowed to dry under ambient conditions (50±10% RH 8 and 72±5 °F) for 24 hours. Visual evaluation of the dry film shall reveal no cracks. 9 10 9-34.3 Plastic 11 In the first sentence of the last paragraph, "Federal Standard 595" is revised to read "SAE AMS 12 Standard 595". 13 14 9-34.3(2) Type B — Pre-Formed Fused Thermoplastic 15 In the last two paragraphs, each reference to "Federal Standard 595" is revised to read "SAE 16 AMS Standard 595". 17 18 9-34.3(4) Type D — Liquid Cold Applied Methyl Methacrylate 19 The Test Method value for Adhesion to PCC or HMA, psi is revised to read "ASTM D45411". 20 21 9-34.4 Glass Beads for Pavement Marking Materials 22 In the Test Method column of the table titled Metal Concentration Limits, "EPA 3052 SW-846 23 6010C" is revised to read "EPA 3052 SW-846 6010D". 24 25 9-34.5(1) Temporary Pavement Marking Tape — Short Duration 26 This section, including title, is revised to read: 27 28 9-34.5(1) Temporary Pavement Marking Tape — Short Duration (Removable) 29 Temporary pavement marking tape for short duration (usage is for up to two months) shall 30 conform to ASTM D4592 Type I except that black tape, black mask tape and the black 31 portion of the contrast removable tape, shall be non-reflective. 32 33 9-34.5(2) Temporary Pavement Marking Tape — Long Duration 34 This section's title is revised to read: 35 36 Temporary Pavement Marking Tape — Long Duration (Non-Removable) 37 J/ 38 The first sentence is revised to read: 39 40 Temporary pavement marking tape for long duration (usage is for greater than two months ' 41 and less than one year) shall conform to ASTM D4592 Type II. 42 43 ASTM E2176 is deleted from the second sentence. ' 44 45 9-34.7(1) Requirements 46 The first paragraph is revised to read: 47 48 Field performance evaluation is required for low VOC solvent-based paint per Section 9- 49 34.2(4), Type A — liquid hot applied thermoplastic per Section 9-34.3(1), Type B — 50 preformed fused thermoplastic per Section 9-34.3(2), Type C — cold applied preformed CITY OF EVERETT AMENDMENTS PACIFIC AVENUE TO INTERURBAN TRAIL BICYCLE SAFETY PROJECT 8/12/2019 STATE FUND#HLP PB17(014);COE#PW3688 Page AM-143