Road Construction Northwest Inc 12/31/2019

CITY OF EVERETT SPECIAL PROVISIONS 5-04.3(3)C Pavers Provide HMA pavers that are self-contained, power-propelled units, with an internally heated vibratory screed and shall be capable of spreading and finishing courses of HMA plant mix material in lane widths required by the paving section shown in the Plans. ' Provide HMA paver in good condition and have the most current equipment available from the manufacturer for the prevention of segregation of the HMA mixture installed in good condition and in working order. Provide equipment certification listing the make, model, and year of the paver and note retrofitting of any equipment. Operate the screed in accordance with the manufacturer's recommendations and so it effectively produces a finished surface of the required evenness and texture without tearing, shoving, segregating, or gouging the mixture. Provide a copy of the manufacturer's recommendations upon City's request. Extensions producing the ' same results, including ride, density, and surface texture as obtained by the primary screed will be allowed. Do NOT use extensions without augers and an internally heated vibratory screed in the Traveled Way. ' When specified in the Contract, reference lines for vertical control will be required. Place lines on both outer edges of the Traveled Way of each Roadway. Horizontal control utilizing the reference line will be permitted. Control the grade and slope for intermediate lanes automatically from reference lines or by means of a mat referencing device and a slope control device. When the finish of the grade prepared for paving is superior to the established tolerances and when, in the opinion of the Engineer, further improvement to the line, grade, cross-section, and smoothness can best be achieved without the use of the reference line, a mat referencing device may be substituted for the reference line. Substitution of the ' device will be subject to the continued approval of the Engineer. A joint matcher may be used subject to the approval of the Engineer. The reference line may be removed after the completion of the first course of HMA when approved by the Engineer. Whenever the Engineer determines that any of these methods are failing to provide the necessary vertical control, the reference lines will be reinstalled by the Contractor. Furnish and install all pins, brackets, tensioning devices, wire, and accessories necessary for satisfactory operation of the automatic control equipment. If the paving machine in use is not providing the required finish, the Engineer may suspend Work as allowed by Section 1-08.6. Thoroughly remove any cleaning or solvent type liquids spilled on the pavement before paving proceeds. 5-04.3(3)D Material Transfer Device or Material Transfer Vehicle Provide a Material Transfer Device/Vehicle (MTD/V) with the Engineer's approval, unless otherwise required by the Contract. Where an MTDN is required by the contract, the Engineer may approve paving without an MTD/V, at the Contractor's request. The Engineer will determine if an equitable adjustment in cost or time is due. Mix the MTDN when used with the HMA after delivery by the hauling equipment and prior to laydown by the paving machine. Sufficiently mix the HMA to obtain a uniform temperature throughout the mixture. The length of the windrow for windrow elevator may be limited in urban areas or through intersections at the discretion of the Engineer. To be approved for use, provide an MTV meeting the following: Watermain Replacement"U" Division 5—SURFACE TREATMENTS October 1, 2019 AND PAVEMENTS WO No.—UP3698 SP-151