3530 COLBY AVE COCOON HOUSE 2020-01-13

Lighting, Motor, and Electrical Permit Checklist, Pg. 2 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: COCOON HOUSE YOUTH CENTER Date 10/6/2017 The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Washington State Energy Code,Commercial Provisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes C405.2.5- Hotel/motel guest Indicate method of automatic control-vacancy or captive key NA Item 3 rooms control of all installed luminaires and switched receptacles in NA NA guest room C405.2.5- Supplemental task Indicate method and location of automatic shut-off vacancy Yescontrol for supplemental task lighting,including under-shelf or A SERIES NA Item 4 lighting under-cabinet lighting Indicate on plans eligible non-visual lighting applications, NA NA include sq.ft.area of each lighting control zone; _ C405.2.5- Lighting for non- Indicate on plans that non-visual lighting are controlled NAindependently from both general area lighting and other lighting NA NA Item 5 visual applications applications within the same space; _ Indicate method of manual lighting control and applicable NA NA automatic lighting control _ Indicate on plans that lighting equipment for sale or demonstration are controlled independently from both general Lighting equipment NA NA C405.2.5- area lighting and other lighting applications within the same NA Item 6 for sale or space; demonstration Indicate method of manual lighting control and applicable NA NA automatic lighting control _ Identify on plans egress fixtures that function as both normal A SERIES NA and emergency means of egress illumination; _ Provide calculation of lighting power density of total egress A SERIES NA Yes C405.2.5- Means of egress lighting; Item 7 lighting If total egress lighting power density is greater than 0.02 W/sq. ft.,indicate on plans egress fixtures requiring automatic shut-off A SERIES NA during unoccupied periods; Indicate method of automatic shut-off control A SERIES NA Indicate on exterior lighting plans and fixture schedules the automatic lighting control method,control sequence,and NA NA locations served; For building facade and landscape lighting,indicate automatic controls shut off lighting as a function of dawn/dusk and fixed NA NA NA C405.2.7 Exterior lighting opening/closing time; controls For all other exierior lighting,indicate automatic controls shut off lighting as a function of available daylight;include control sequence that also reduces lighting power by at least 30% NA NA between 12am-6am,or from 1 hour after closing to 1 hour before opening,or based upon motion sensor Exterior building For building grounds fixtures greater than 100 watts,indicate NA C405.5.1 grounds lighting on plans whether fixtures have efficacy greater than 80 lumens NA NA controls or;are controlled by motion sensor,or are exempt lighting per C405.5.2 Indicate location(s)of master control switch(es)intended to Area controls- control multiple independent switches;circuit breaker may not A SERIES NA Yes C405.2.5 Master control be used as a master control switch; switches and circuit power limit Verify that no 20 amp circuit controlled by a single switch or A SERIES NA automatic control is loaded beyond 80% _ To comply with additional efficiency package option,indicate on plans all interior lighting fixtures that are individually A SERIES NA addressed and provided with continuous dimming,or exception Enhanced digital taken; Yes C406.4 - - lighting controls Include calculation of percent total installed interior lighting power that is configured with required enhanced lighting control A SERIES NA functions(min 90%to comply with additional efficiency package option) If claiming lighting system commissioning exemption provide A SERIES NA supporting calculation; Identify applicable commissioning documentation requirements Yes C405.13 Lighting system per Section C408 or eligibility for exception; A SERIES NA C408.3 functional testing Provide written procedures for functional testing of all A SERIES NA automatic controls and describe the expected system response (7(41/5)