9606 19TH AVE SE PREMIER STORAGE 2018-01-02 MF Import

property and shall be located so that the bottom of the sign is a minimum of 7 feet above the curb. Where fire lanes are adjacent to buildings or structures and when approved or directed by the Fire Code Official, the signs may be placed on the face of the building or structure. Where directed by the Fire Code Official, specific areas shall be designated and those areas are to be marked with diagonal striping across the width of the fire lane. Diagonal marking shall be used in conjunction with painted curbs and/or edge striping and shall run at an angle of 30 to 60 degrees from one side to th, other. These diagonal lines shall be in red traffic paint, parallel with each other, at least 6 inches in width and 24 inches apart. Lettering shall appear as above. 6. A fire hydrant is required within 200 driving feet, but not closer than 50 feet, of every structure. Location of the hydrant(s) shall be approved by the Fire Code Official. 7. Fire Ilydrants - Locations as plamted are acceptable. 8. Building A - Based upon 84,318 square feet of Type IIA, sprinklered construction, the fire flow requirement is 2,125 gptn. Building B - Based upon 7,740 square feet of Type IIA, sprinklered construction, the fire flow requirement is 1,500 gpm. 9. Portable Fire Protection - A portable fire extinguisher with a minimum U.L. rating of' 2-A:10-B:C shall be provided within 75 feet of travel on all floors of each building during construction and prior to occupancy. 10. Fire Alann System - An approved automatic fire detection system shall be provided as required by City Ordinance No. 3021-07, Chapter 16.76, of the Everett Municipal Code. Plans fe:- such system shall be submitted to the Fire Code Official for review and approval prior to installation. Submittal shall include cut sheets of all equipment intended for use. Appropriate trip tests, witnessed by a Fire Department Inspector, shall be performed, along with a certificate of completion, prior to final acceptance of the system. Fire alarm systems shall be installed according to NFPA Chapter 72. Installation of fire alarm components, including basic wiring, may not commence before plans are approved by the Fire Department Plan Reviewer. Fire alarm drawings must be professionally rendered, in sufficient detail, and must be internally consistent. Riser diagrams must match installation plans and load calculations. Components must be listed and approved for use together. Changes to plans must include new drawings and calculations and must be approved by the Fire Department Plan Reviewer prior to installation. Fire alarm installation is subject to field inspection by a Fire Department Inspector. An approved set of plans and the Engineering & Public Services Department electrical permit must be present for any installation inspection. Fire alarm systems shall be installed under permit of the City of Everett Engineering & Public Services Department. Electrical inspections and approval are required prior to calling for acceptance tests. Call (425) 257-8810 for permit information Final MDNS SL'}'A ' and tiSl'12-00? C,/ 1