Laserfiche WebLink
4. SWPPP NARRATIVE <br /> The intent of this section is to provide the information necessary to support the <br /> engineering plans in order to implement a design that will; reduce, eliminate or prevent the <br /> discharge of stormwater pollutants, meet or exceed the water quality and sediment <br /> management standards for the City and State, and prevent adverse impacts to the <br /> receiving waters for this project. Note; this narrative is intended to support the SWPPP <br /> that is included with the Drainage Plans also a part of this submittal package to the City. <br /> A. SITE GRADING/EROSION CONTROL RISK ASSESSMENT <br /> Area proposed to be cleared/worked: 0.14 acres <br /> Average slope for the site: 3% (Area of Disturbance Only) <br /> Erosion Hazard of Soil Low <br /> Critical Areas downslope Yes <br /> Site is upstream of an ESA Stream No <br /> Based on the above information and the fact that the area of the site to be disturbed is flat <br /> and construction site runoff will pass through silt fencing or other perimeter filtration <br /> features prior to leaving the site, and that if site conditions warrant, additional BMP's can <br /> be implemented as corrective measures the Risk Category for this site is Low Risk. <br /> B. SWPPP MINIMUM ELEMENTS <br /> 1: Preserve Vegetation and Mark Clearing Limits <br /> The first step in the construction process is for the contractor to flag or fence the limits of <br /> clearing/disturbance (BMP C103) prior to any other construction activity. The engineering <br /> plans locate and provide the square footages for the areas of grading, clearing, impervious <br /> surfaces and un-disturbed areas on the proposed site. Approximately 100% of the project <br /> parcel will be cleared or disturbed for this project. <br /> 2: Establish Construction Access <br /> The SWPPP calls for the existing asphalt driveway (BMP C105) to be used as the <br /> construction entrance. Since this project will utilize the existing driveway for a construction <br /> access this feature will be available immediately and may require some maintenance to <br /> ensure proper function during the site work. At this time winter work is expected during <br /> the wet season. <br /> 3: Control Flow Rates <br /> This project is below the thresholds requiring flow control for the project. <br /> 4: Install Sediment Controls <br /> This site SWPPP proposes to maintain the existing asphalt entrance (BMP C105), <br /> vegetative buffer (BMP C102), silt fencing (BMP C233) if necessary and retention of the <br /> • existing vegetation (BMP C101) that will provide a vegetated strip between the cleared <br /> areas and any property line. The construction of these features should be completed <br /> before the clearing and grading of the site. Mulch (BMP C121) will also be used on the <br /> exposed soil as necessary to limit erosion. In addition, streets shall be cleaned as needed <br /> Kromer SFR 18-0303 <br /> April 2018 Page 6 <br /> Revised August 2018 <br />