12906 19TH AVE SE 2020-05-18 - Laserfiche WebLink

Lighting, Motor, and Transformer Permit Documents Checklist LTG-CHK 2012 Washington State Energy Code Compliance Forms for Commercial Buildings including R2&R3 over 3 states and all R1 Revised Jan 2014 Project Address Fred Meyer/Kroger#458 Date 7/10/2017 The following information is necessary to check a permit application for compliance with the lighting,motor,and transformer requirements in the Washington State Energy Code,Commercial Provisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes Provide fixture schedule with fixture types,lamps,ballasts,and Lightng Plan E1.1 rated watts per fixture; C405.5.1 Identify spaces eligible for lighting power exemption on plans C405.5,1,1 Total connected and in compliance forms; Yes C405,5.12 C405.5,1,3 interior lighting power Identify lighting equipment eligible for exemption in fixture C405,5.1,4 schedule and in compliance forms; Indicate that exempt lighting equipment is in addition to general area lighting and is controlled independently Yes C405.4 Exit signs Provide exit sign types and rated watts per fixture in fixture Lightng Plan E1.1 schedule(maximum 5 watts per fixture) C405.10 Cooler and freezer For lighting in walk-in coolers and freezers,and refrigerated NA C405.11 lighting warehouse coolers and freezers,provide rated lamp efficacy(in lumens per watt)in fixture schedule Lighting Power Calculation-Indicate compliance path taken Complete required compliance forms—proposed wattage per NA C405.5.2 Building Area Method building area does not exceed maximum allowed wattage per building area.Identify locations of building areas on plans Complete required compliance forms—total proposed wattage Yea C405.5.2 Space-By-Space does not exceed maximum allowed wattage.Identify locations Lightng Plan E1.1 Method of space types on plans,including retail display areas as applicable EXTERIOR LIGHTING POWER&EFFICACY(Section C405.6) Provide fixture schedule with fixture types,lamps,ballasts,and Lightng Plan E1.1 Total connected rated watts per fixture; Yes C405,6.2 exterior lighting Identify exterior applications eligible for lighting power power exemption on plans and in compliance forms; Indicate that exempt exterior lighting is controlled independently from non-exempt exterior lighting NA Table Exterior lighting zone Indicate building exterior lighting zone as defined by the AHJ C405.6.2(1) Exterior building For building grounds fixtures rated at greater than 100 watts, NA C405.6.1 grounds lighting provide rated lamp efficacy(in lumens per watt)in fixture schedule Exterior lighting Complete required compliance form—proposed wattage for NA C405.6.2 exterior lighting plus base site allowed does not exceed power calculations maximum allowed MOTORS&TRANSFORMERS(Sections C405.8,C405.9) NA C405.8 Electric Motors For motors not part of an HVAC system,provide electric motor schedule on electrical plans with hp,rpm,and rated efficiency NA C405,9 Transformers Provide distribution transformer schedule on electrical plans with transformer size and efficiency If"no"is selected for any question,provide explanation: C4O5.2.2.1 Lighting controlled by occupancy sensors.