Laserfiche WebLink
• <br /> F <br /> 2/25/2020 Page 1 <br /> City of Everett <br /> 11:39:21AM <br /> INSPECTION ACTIVITY REPORT '~- .. <br /> Permit No. C1804-006 Site Address 2915 17TH ST <br /> Applied 4/17/2018 Applicant OWNER Lot <br /> Approved 5/31/2018 Owner SHAPIRO RACHEL Block <br /> Issued 6/4/2018 Contractor OWNER Tract <br /> Parent Permit No. Description SFR ALTERATIONS <br /> Notes OTHER PLUMBING=SUPPLY AND WASTE LINES <br /> Scheduled Completed Tune Inspector Result Remarks Inspector's Comments <br /> 6/4/2018 PLUMB SDP VOIDED(KLC 6/3/2018 6:41 PM Anthony Shapiro <br /> 02-GROUND 6/6/2018) Polypipe hook up to meter request <br /> inspection to enable us to cover poly pipe <br /> Trench <br /> Contact Name:Anthony Shapiro <br /> Site Address:2915 17TH ST <br /> Phone:4257785400 <br /> e-Mail:tonys@adshapiro.com <br /> 6/5/2018 6/5/2018 PLUMB 05-OTHER SDP CORRECTION 1.Remove crushed rock from the ditch.The <br /> sharp points and edges will puncture the <br /> water line. <br /> 6/22/2018 6/22/2018 PLUMB SDP PARTIAL APPIt OK to cover water line from meter to HSE. <br /> 02-GROUND Note:OK to use air admittance valve on <br /> kitchen sink or washer <br /> As noted:air admittance valve must be <br /> open to atmosphere for performance and <br /> service. <br /> 6/22/2018 6/22/2018 BLDG DWF APPROVAL OK to cover <br /> 07-EXTERIOR <br /> 6/28/2018 6/28/2018 BLDG DWF CORRECTION Need electrical rough in,plumbing sign off, <br /> 08-FRAMING and mechanical before framing inspection. <br /> 8/31/2018 8/31/2018 PLUMB SDP CORRECTION 1.Re-pipe waste/vent for toilet <br /> 03-ROUGH IN 2.Washer must be vented to the outside-no <br /> studor vent. <br /> 3.Water-OK <br /> 10/3/2018 10/3/2018 PLUMB SDP APPROVAL As noted Studor vents cannot be in the wall. <br /> 03-ROUGH IN Ok to install inside of the cabinet. <br /> Note:Mechanical inspection not ready at <br /> this time. <br /> 10/24/2018 10/24/2018 BLDG DWF CORRECTION Need mechanical, <br /> 08-FRAMING electrical rough ins <br /> 12/4/2018 12/4/2018 MECH 04-ROUGH SDP CORRECTION Range hood/kitchen exhaust must be a <br /> IN minimum of 6"duct(metal duct-no <br /> flex),Insulate duct to R-4 <br /> Bathroom and laundry exhaust shall be <br /> insulated to a minimum of R-4. <br /> 12/11/2018 12/11/2018 MECH 04-ROUGH SDP APPROVAL <br /> IN <br /> 12/14/2018 12/14/2018 BLDG DWF APPROVAL As noted Contractor to install seismic straps to 4x10 <br /> 08-FRAMING beams to top plates. <br /> INSP12 CRIOVsYSTEMS <br />