Laserfiche WebLink
WRD 23.30 Page 4 <br /> 2. Wallboard systems with less than one percent asbestos content. Where full-depth <br /> sampling or reassessment of the wallboard system has been conducted in accord <br /> with section III.A of this document and the wallboard system is found to contain <br /> less than one percent asbestos or trace asbestos. L&I will not consider the work <br /> will an asbestos project. <br /> In such cases, WISHA enforcement staff must assess that the basic asbestos work <br /> practice requirements as given in WAC 296-62-17712(2),particularly use of wet, <br /> non-aggressive methods and prompt clean-up. Vacuums used must be HEPA <br /> filtered. Worker training must include asbestos awareness and hands on training <br /> as given in WAC 296-62-07722(5), Respiratory protection must be based on <br /> overall dust levels. A competent person must be assigned and trained under the <br /> requirements of WAC 296-62-07728. <br /> 3. Wallboard systems where no asbestos has been detected. Where appropriate <br /> sampling and analysis has been performed and no asbestos has been detected,no <br /> provisions of the asbestos standard will be enforced by WISHA compliance staff. <br /> Note: Lead and silica are also commonly found in wallboard systems and any <br /> work should be evaluated to ensure any significant hazard due to these materials <br /> is addressed. Even where no specific hazard is identified,care should still be <br /> exercised in demolition or other work involving the wallboard systems. Total <br /> particulate standards from WAC 296-62, Part H,will apply, as well as <br /> requirements for demolition in WAC 296-155,Part S. General work practices <br /> including misting of debris,non-aggressive work methods and prompt clean-up as <br /> given in III.B.2 above will help meet these basic requirements and control any <br /> low levels of contaminants not found during pre-work inspections. <br /> Approved: <br /> Michael Wood <br /> Senior Program Manager,WISHA Policy&Technical Services <br /> For further information about this or other WISHA Regional Directives,you may contact <br /> WISHA Policy& Technical Services at P.O. Box 44648 or by telephone at(360)902-5503. <br /> You also may review policy information on the WISHA Website <br /> (http://www.wa.gov/lni/wisha). <br />