3214 BROADWAY BROADWAY KINECT APARTMENTS 2021-08-11

a i CITY OF EVERETT STORMWATER MANAGEMENT MANUAL • 41111 3.3.16 BMP C235: Straw Wattles Purpose Straw wattles are TESC barriers consisting of straw that is wrapped in biodegradable tubular plastic or similar encasing material. They reduce the velocity and can spread the flow of rill and sheet runoff,and 4111 can capture and retain sediment. Straw wattles are typically 8 to 10 inches in diameter and 25 to 30 feet • in length. The wattles are placed in shallow trenches and staked along the contour of disturbed or newly fib constructed slopes. See Figure 3.4 for typical construction details. • Conditions of Use • Disturbed areas that require immediate erosion protection ID • Exposed soils during the period of short construction delays,or over winter months • On slopes requiring stabilization until permanent vegetation can be established 1111 • Straw wattles are effective for one to two wet seasons 11111 • If conditions are appropriate, wattles can be staked to the ground using willow cuttings for added 4111 revegetation 1111 • Rilling can occur beneath wattles if not properly entrenched and water can pass between wattles • if not tightly abutted together. • Design Criteria 1. It is critical that wattles are installed perpendicular to the flow direction and parallel to the slope • contour. i 2. Narrow trenches should be dug across the slope on contour to a depth of 3 to 5 inches on clay soils and soils with gradual slopes. On loose soils, steep slopes, and areas with high rainfall, the • trenches should be dug to a depth of 5 to 7 inches,or one-half to two-thirds of the thickness of the • wattle. 3. Start building trenches and installing wattles from the base of the slope and work up. Excavated • material should be spread evenly along the uphill slope and compacted using hand tamping or other methods. • 4. Construct trenches on contours at intervals of 10 to 25 feet apart depending on the steepness of the slope, soil type,and rainfall. The steeper the slope,the closer together the trenches. • 5. Install the wattles snugly into the trenches and abut tightly end to end. Do not overlap the ends. • 6. Install stakes at each end of the wattle,and at 4-foot centers along entire length of wattle. ID 7. If required, install pilot holes for the stakes using a straight bar to drive holes through the wattle • and into the soil. ID 8. At a minimum, wooden stakes should be approximately 0.75 x 0.75 x 24 inches. Willow cuttings • or three-eighths-inch reinforcement bar can also be used for stakes. • Maintenance Standards • 1. Stakes should be driven through the middle of the wattle, leaving 2 to 3 inches of the stake protruding above the wattle. • 2. Wattles may require maintenance to ensure they are in contact with soil and thoroughly entrenched,especially after significant rainfall on steep sandy soils. 1111 • Volume It—Construction Stormwater Pollution Prevention 3-58 0 a