1920 MERRILL CREEK PKY MARKET READY 2021-01-04

Interior Lighting - building Area Method LTG-INT-BLD 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all F Revised Nov 2017 Project Title: Merrill Creek Synsor Building Market Ready Date 1/1/2017 Calculation 0 New Construction b Addition- 0 Addition For Building Department Use Area NOTES stand alone +existing " Spaces where <50%of Spaces where z 50%of ti Spaces where the Use luminaires are replaced luminaires are replaced is changing (C505) LPA # Standard 0 Additional Efficiency Package Option Q Calculation C406.3 Reduced Interior Lighting Power To comply with C406.3,the Proposed LPD shall be 25%lower than the Target LPA.Type Refer to C406.3 for additional requirements. User Note Maximum Allowed Lighting WattagtoTE 9 Watts Allowed Location(plan#, Gross Interior Allowed (watts/ft2 x area) Building Area room#,or ALL) Area Description Area in ft2 Watts per ft2 NOTE 2 Office All Open office,closed offices 14304 0.66 9441 Total 14304 Proposed Lighting Wattage Location(plan#, Number of Watts per Building Area room#) Fixture Description NOTE 3,4,5,6 Fixtures Fixture NOTE 7 Watts Proposed Open Office Office/Closed 2x4 recessed fixture 75 36 2700 Offices Office Open Office 2x2 recessed fixture 18 18 324 Office Open Office 6"can 20 17 340 Office Open Office 1x8 linear 18 40 720 Compliance by Building Area' I otal Allowed I otal Proposed Intenor Lighting Building Area Warnings Watts Watts Power Allowance Office Confirm all fixtures are reported under proposed lighting-low watts 9441 4084 COMPLIES relative to maximum allowed. Note 1-List all unique building areas per Table C405.4.2(1)that occur in the Totals 9441 4084 project scope.Select building area category from drop down menu. Note 2-Unlit Message-Enter lighting fixture information for this building area surface in Proposed Lighting Wattage table to generate Lighting Power Allowance. Note 3-Proposed fixtures must be listed in the building area in which they occur.List all proposed lighting fixtures including exempt lighting equipment and existing-to-remain fixtures. Note 4-For proposed Fixture Description,indicate fixture type,lamp type(e.g. T-8), numberof lamps in the fixture,and ballast type(if included). For track lighting,list the length of the track(in feet)in addition to the fixture, lamp,and ballast information. 9� Note 5-For lighting equipment eligible for exemption per C405.4.1,note exception number and leave Watts/Fixture blank. Note 6-Existing-to-remain fixtures shall be included in the Proposed Lighting Wattage table in the same manner as new fixtures.Identify as existing in fixture description. Note 7-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.