6617 ASSOCIATED BLVD AMAZON 2022-05-23

• • Lighting, Motor, and Electrical Permit Checklist, Pg. 5 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised Nov 2017 DWS5-Everett WA Tenant Improvement Date 5/22/2020 The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Applicability Location in building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes MOTORS,TRANSFORMERS,ELECTRIC METERS,INTERIOR TRANSPORTATION C405.6 Electrical Include electrical transformer schedule on electrical plans; transformers indicate transformer size,efficiency,or exception taker Dwelling unit Indicate on electrical plans that each dwelling unit in Group R-2 C405.7 electrical energy has a separate electrical energy meter consumption Electric motor Include all motors,including fractional hp motors,in electric C405.8 efficiency motor schedule on electrical plans;indicate hp,rpm,rated efficiency.or exception applied For luminaires in each elevator cab,provide calculated average efficacy of combined fixtures that indicates efficacy is not less than 35 lumens per watt; C405.9.1 Elevator cabs Indicate rated watts per cfm for elevator cab ventilation fans do not exceed 0.33 watts per cfm Indicate automatic controls that de-energize lighting and ventilation fans when elevator is stopped and unoccupied for a period of 15 minutes or more Escalators and Indicate escalators comply with ASME A17.1/CSA B44; C405.9.2 moving walks automatic controls are configured to reduce operational speed tc the minimum permitted when not in use C405.9.3 Regenerative drive Indicate all one-way down or reversible escalators are provided with a variable frequency regenerative drive DOCUMENTATION AND SYSTEM REQUIREMENTS TO SUPPORT COMMISSIONING(Cx) Indicate that all electrical systems(receptacles,transformers, motors,vertical and horizontal transportation)for which the WSEC requires control functions and/or configuration to Scope of electrical erform specific functions are required to be commissioned C408.3 power and lighting total building lighting load is>20 kW,or where total systems lighting load of luminaires requiring daylight sensing and/or commissioning occupancy control>10 kW,indicate that all automatic lighting control systems are required to be commissioned;or provide building lighting power calculation demonstrating eligibility for _ex.-otion' Indicate Cx requirements in plans and specifications for all icable electrical and lighting control systems per C408; In.-ude general summary with at minimum Items thru 4 of the C405.13 Commissioning Cx plan per C408.1.2 including:narrative description of C408.1.1 requirements in activities,responsibilities of the Cx team,schedule of activities C408.1.2 construction including verification of project close out documentation per C408.1.4.2 documents C103.6.and conflict of interest plan(if reauiredl: C103.6 Include in general summary that a Cx project report or Compliance Checklist(Figure C408.1.4.2)shall be completed by the Certified Cx Professional and provided to the owner prior to the final electrical inspection Functional Identify in plans and specifications the intended operation of all C408.3.1 performance testing equipment and controls during all modes of operation,including criteria interfacing between new and existing-to-remain system, PROJECT CLOSE OUT DOCUMENTATION Project dose out Indicate in plans that project close out documentation is required C103.6.3 documentation including WSEC lighting compliance forms and calculations that requirements document all interior and exterior lighting area and/or surface types,lighting power allowances and installed densities If"no"is selected for any question,provide explanation: End of Lighting,Motor&Transformer Permit Documents Checklist