10521 19TH AVE SE 2022-05-23 - Laserfiche WebLink

Instructionsfor • • •• 2015 WSEC Compliance Forms for Commercial Buildings including R2, R3, & R4 over 3 stories and all R1 Revised Jun 2016 For projects complying via the Prescriptive Path, enter the vertical fenestration area, gross wall area (includes vertical fenestration, doors, etc), skylight area and gross roof area (includes skylights, mechanical equipment curbs, etc) directly Fenestration into the Vertical Fenestration and Skylight Area Calculation input cells on the ENV -SUM form. The form will calculate the Window -to -Wall and Skylight -to -Roof ratios. Area For projects complying via the Component Performance Path, the Vertical Fenestration and Skylight Area inputs in the ENV -SUM form are write protected. Enter all applicable envelope information in the ENV-UA form. The resulting Window -to -Wall and Skylight -to -Roof ratios will auto fill into the ENV -SUM form from the ENV-UA form. The prescriptive vertical fenestration target area is 30%. This target increases to 40% if the project complies with the Vertical requirements of C402.3.1.1 <_ 3 story building with 50% floor area in the daylight zone, C402.3.1.1 < 3 story building with 25% of net floor area in the daylight zone, C402.3.1.3 high performance vertical fenestration, or C402.3.1.4 Dedicated Fenestration outdoor air system (DOAS). Alternates If the project is eligible for one of these alternates, select the corresponding button on Line 30 of the ENV -SUM form. This will re -calculate the prescriptive target area in the ENV -SUM and ENV-UA forms based on 40%. Target Area Adjustment is required if the project exceeds the prescriptive target area for vertical fenestration or Target Area skylights. Adjusted target areas are automatically calculated in the ENV-UA form using envelope assembly areas you Adjustment enter for your project. Adjusted target areas will appear in the Target UA column in the ENV-UA form. Refer to Target Area Adjustment worksheet for the supporting calculations. The forms should print on any printer supported by your operating system. You will need to have the following TrueType fonts installed under Windows: Arial, Times New Roman, Courier New and Wingdings. These are all standard Windows fonts. If you are losing form details when printing, you may have a shortage of printer memory. Try printing problem pages Printing individually. By default, only the active worksheet is printed. To print more than one worksheet at a time, open your print set-up menu and select either the page range you wish to print or Entire Workbook. Forms (worksheets) in a workbook may not be deleted because the file is locked. To print blank forms to fill out by hand, delete all of the heading information at the beginning of ENV -SUM and select Blank Forms the desired Occupancy Group. For each radio button group there is a button labeled "Clear." Clicking this button will clear the other buttons so that they will print as empty circles. The "Clear" button will not print. End of Instructions for Electronic Forms