Laserfiche WebLink
• <br /> EVERETT HOUSING AUThORITY EVERETT, WA <br /> Administrative Office Upgrades January 13, 2020 <br /> b. Sliding or Folding Doors: 5 lbf applied parallel to door at latch. <br /> c. Fire Doors: Minimum opening force allowable by authorities having jurisdiction. <br /> 3. Bevel raised thresholds with a slope of not more than 1:2. Provide thresholds not more <br /> than 1/2 inch high. <br /> 4. Adjust door closer sweep periods so that, from an open position of 90 degrees, the <br /> door will take at least 5 seconds to move to a position of 12 degrees from the latch. <br /> 5. Adjust spring hinges so that, from an open position of 70 degrees, the door will take at <br /> least 1.5 seconds to move to the closed position. <br /> 2.3 SCHEDULED DOOR HARDWARE <br /> A. Provide products for each door that comply with requirements indicated in Part 3 "Door <br /> Hardware Schedule"Article to comply with requirements in this Section. <br /> 1. Door hardware and ratings as scheduled on Drawings. <br /> 2.4 BUTT HINGES <br /> A. Manufacturer listed as basis of design: Stanley. Accepted: Hager, McKinney, Bommer <br /> 1. B168 (Interior Heavy Use Doors) 652 <br /> 2. Furnish NRP on all doors <br /> B. Hinge width shall be as required to clear projecting trim allowing maximum degree of <br /> opening. <br /> C. Quantity: <br /> 1. 1-1/2 pair up to and including 90" in height, minimum, or as scheduled. <br /> 2. 2 pair over 90" in height, minimum, or as scheduled. <br /> 3. 2 pair for doors 3'-6" and greater in width, or as scheduled. <br /> 2.5 LOCKSETS, LATCHSETS, AND DEADLOCKS <br /> A. Lock Functions: As indicated in door hardware schedule. <br /> B. Manufacturer listed as basis of design: Schlage if existing building standard is not <br /> available. <br /> C. Design: Cylinder locksets, Match existing building standard. AL series with Jupiter lever if <br /> building standard is not available. Functions as indicated in the hardware groups. <br /> D. Provide curved lip strikes. Furnish flat lipped strikes on locks with pairs of doors with <br /> overlapping astragal <br /> E. Locksets and latchsets shall be furnished with sufficient strike lip to protect trim. <br /> F. Provide standard 6-pin cylinders to match existing keying system for locksets and exit <br /> devices. <br /> DOOR HARDWARE 087100 - 5 <br />