820 CADY RD BLDG D BLDG D 2021-11-01

0. S Drew Martin From: Drew Martin Sent: Thursday, March 4, 2021 12:45 PM To: 'Rachel Petty' Cc: Joshua Lipka Subject: RE: Permit Question 820 Cady Road Hello, Rachel. I quickly reviewed the documents. These are much improved. However, multiple comments still require additional action (itemized for consistency with the original comments): 1. The Architectural Floor Plan appears to include demolition and movement of multiple walls throughout, while the Structural Floor Plan only shows modification of one minor wall section. Some dashed lines are shown, but are not clear if these represent demolition. Other notes state to remove and replace fixtures, but it is not clear which fixtures are being replaced (all of them?). All proposed work should be clearly delineated (e.g., dark line weight, shaded walls, etc.). Note that the east bathroom has not access door per the architectural plan, and the southwest bedroom closet appears to be open to the hallway per the structural plan. The smoke detector in the southeast bedroom appears to be too close to the bathroom door. A detail for interior wall construction, including top and bottom fasteners and blocking, and continuity if the fire-membrane, should be provided. 2. Please indicate the story on which the unit occurs if this is multi-story building. Note that the structural drawing indicates"Second Floor", but it is anticipated that the work area is at the first story, and the floor framing above (i.e., second floor) is being modified. 4. The plan appears to include modification of interior walls throughout the space. It is anticipated that some of these may be load-bearing walls. Note that the extent of work is not clear; see Comment 1. The proposed work should be clarified in the Floor Plan. The existing load paths should be verified. Additional structural revisions should be performed as needed. Verify if foundations are required for the new posts supporting the kitchen beam. 5. The project appears to include new floor beams per the structural drawings.These must be wrapped to provide the required fire protection. Detail 5/A1 is not sufficient. A separate detail for the beam should be provided. If other conditions exist, appropriate details should be similarly provided. 6. The Architectural Floor Plan includes as note to provide radiation dampers. The following should be addressed: a. The drawings do not clearly indicate if the propose work include moving/replacing the existing exhaust fans for the bathroom. This should be shown. See Comment 1. b. Radiation dampers are not permitted for the kitchen hood. The drawings should include details for a shaft, or must locate the vent below the rated assembly above (e.g., in a soffit, etc.) and vent directly to the outside. The vent route should be shown and details provided to clarify the proposed construction. Drew Martin, P.E.,S.E. LiAssociate Engineer—Commercial Plans Examiner I Permit Services 425.257.8813 13200 Cedar Street, 2nd Floor, Everett,WA 98201 EVERETT Hours: M/W/Th/F: 7:30am-12:00pm & 1:OOpm-3:OOpm;Tu: 1:OOpm-3:OOpm everettwa.gov I Facebook I Twitter 1