1803 112TH ST SE BANK OF AMERICA 2021-11-08

Lighting, Motor, and Electrical Permit Checklist, Pg. 2 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised Nov 2017 Project Title: Bank of America Ext.Lighting Renov.,Everett,WA. Date 3/4/2020 The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes C405.2.5- Hotel/motel guest Indicate method of automatic control-vacancy or captive key NA tern 3 rooms control of all installed luminaires and switched receptacles in guest room C405.2.5- Supplemental task Indicate method and location of automatic shut-off vacancy NA Rem 4 lighting control for supplemental task lighting,including under-shelf or under-cabinet lighting Indicate on plans eligible non-visual lighting applications, include sq.ft.area of each lighting control zone; C405.2.5- Lighting for non- Indicate on plans that non-visual lighting are controlled NA Rem 5 visual applications independently from both general area lighting and other lighting applications within the same space; Indicate method of manual lighting control and applicable automatic lighting control Indicate on plans that lighting equipment for sale or Lighting equipment demonstration are controlled independently from both general C405.2.5- area lighting and other lighting applications within the same NA Rem 6 for sale or space; demonstration p Indicate method of manual lighting control and applicable automatic lighting control Identify on plans egress fixtures that function as both normal and emergency means of egress illumination; Provide calculation of lighting power density of total egress NA C405.2.5- Means of egress lighting; Rem 7 lighting If total egress lighting power density is greater than 0.02 W/sq. ft.,indicate on plans egress fixtures requiring automatic shut-off during unoccupied periods; Indicate method of automatic shut-off control Indicate on exterior lighting plans and fixture schedules the automatic lighting control method,control sequence,and LU-1 locations served; For building facade and landscape lighting,indicate automatic Exterior lighting controls shut off lighting as a function of dawn/dusk and fixed LU-1 No C405.2.7 controls opening/closing time; For all other exterior lighting,indicate automatic controls shut off lighting as afunction of available daylight;include control sequence that also reduces lighting power by at least 30 between 12am-6am,or from 1 hour after closing to 1 hour before opening,or based upon motion sensor Exterior building For building grounds fixtures greater than 100 watts,indicate on No C405.5.1 grounds lighting plans whether fixtures have efficacy greater than 80 lumens or; controls are controlled by motion sensor,or are exempt lighting per C405.5.2 Area controls- Indicate location(s)of master control switch(es)intended to C405.2.5 Master control control multiple independent switches;circuit breaker may not NA (listed after be used as a master control switch; C405.2.7) switches and circuit Verify that no 20 amp circuit controlled by a single switch or power limit automatic control is loaded beyond 80% ADDITIONAL EFFICIENCY PACKAGE OPTION-ENHANCED DIGITAL LIGHTING CONTROLS To comply with additional efficiency package option,indicate on plans all interior lighting fixtures that are individually addressed Enhanced digital and provided with continuous dimming,or exception taken; NA C406.4 lighting controls 9 9 Include calculation of percent total installed interior lighting power that is configured with required enhanced lighting control functions(min 90%to comply with additional efficiency package option)