1330 COLBY AVE IRG PHYSICAL THERAPY 2022-02-14

• to 0.20. Calculations must include any floor-slab-edges that penetrate the hoistway and thus are considered part of the above-grade walls. C402.1.3 Insulation component R-value method.Building thermal envelope opaque assemblies shall comply with the requirements of Section C402.2 based on the climate zone specified in Chapter 3. For opaque portions of the building thermal envelope intended to comply on an insulation component R-value basis, the R-values for insulation shall not be less than that specified in Table C402.1.3. Commercial buildings or portions of commercial buildings enclosing Group R occupancies shall use the R-values from the"Group R" column of Table C402.1.3. Commercial buildings or portions of commercial buildings enclosing occupancies other than Group R shall use the R-values from the"All other"column of Table C402.1.3. TABLE C402.1.3 OPAQUE THERMAL ENVELOPE INSULATION COMPONENT MINIMUM REQUIREMENTS, R-VALUE METHODa, CLIMATE ZONE 5 AND MARINE 4 All Other Group R Roofs Insulation entirely above R-38ci R-38ci deck Metal buildingsb R-25.+ R-25.+ R-11 LS R-11 LS Attic and other R-49 R-49 Walls,Above Grade Massy R-9.5c ci R-13.3ci Mass transfer deck slab R-5 R-5 edge Metal building R-19ci or R-19ci or R-13+13ci R-13+13ci Steel framed R-13.+ R-19.+ R-10ci R-8.5ci Wood framed and other R-21 int or R-13+7.5ci std or R-15+5ci std R-20+3.8ci std or R-25 std Walls,Below Grade Below-grade walid,h Same as above grade Same as above grade Floors Massy R-30ci R-30ci Joist/framing R-30e R-30e Slab-on-Grade Floors Unheated slabs R-10 for 24"below R-10 for 24"below Heated slabsd R-10 perimeter& R-10 perimeter&under under entire slab entire slab Opaque Door Nonswinging R-4.75 R-4.75 For Si: 1 inch=25.4 mm.ci=Continuous insulation.NR=No requirement.LS= Liner system 2018 Washington State Energy Code CE-27 � l�