1020 NORTH PARK DR 2022-02-23 - Laserfiche WebLink

Table R402.1.1 Footnotes • For SI:1 foot.=304.8 mm,ci.=continuous insulation, int.=intermediateframing. aR-values are minimums.U factorsand SHGC are maximums.When insulation is installed in a cavity which is less than the label or design thickness of the insulation,the compressed R-value of the insulation from Appendix Table A101.4 shall not be lessthan the R-value specified in the table. b Thefenestrati on U-factor column excludes skylights.The SHGC column appliesto all glazed fenestration. ""10/15/21.+TB"means R-10 continuous insulation on the exterior of the wall,or R-15 on the continuous insulation on the interior of the wall,or R-21 cavity insulation plus a thermal break between the slab and the basement wall at the interior of the basement wall."10/15/21.+TB"shall be permitted to be met with R-13 cavity insulation on the interior of the basement wall plus R-5 continuous insulation on the interior or exterior of the wall."10/13"means R- 10 continuous insulation on the interior or exterior of the home or R-13 cavity insulation at the interior of the basement wall."TB"means thermal break between floor slab and basement wall. d R-10 continuous insulation is required under heated slab on gradefloors.See R402.2.9.1. eThere are no SHGC requirements in the Marine Zone. Reserved. g Reserved. h Reserved. 'The second R-value applies when more than half the insulation is on the interior of the mass wall. Reserved. k For single rafter-or joist vaulted ceilings,the insulation may be reduced to R-38. Reserved. m Int.(intermediate framing)denotes standard framing 16 inches on center with headers insulated with a minimum of R-10 insulation. Table R402.1.3 Footnote Nonfenestration U factorsshall be obtained from measurement,calculation or an approved source or as specified in Section R402.1.3. �4t i �.