Laserfiche WebLink
Exterior Lighting LTG-EXT <br /> 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 <br /> Project Title: St.Mary Magdalen Gymnasium Date 3/8/2018 <br /> Exterior Lighting 0 Zone 1 Zone 2 Zone 3 Zone 4 For Building Department Use <br /> Zone Table C 05.5.2(1) <br /> jurisdiction. <br /> Zone selection required to enable LTG-EXT form <br /> Specified by jurisdiction. <br /> Calculation Area 0 0 Addition- O Addition <br /> stand alone +existing <br /> 0 Alteration with<50% 0 Alteration with>_50%ext. <br /> ext.wattage replaced wattage replaced <br /> Building Grounds U Efficacy>80 lumens/watt U Exemption <br /> Applies to luminaires> ❑ <br /> 100 Watts Controlled by motion sensor <br /> Tradable Maximum Allowed Lighting Wattage NOTE 1 Base Site Allowance: 750 <br /> Area(fe),perimeter(If) Allowed Watts Allowed Watts <br /> Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) <br /> Entry Canopies Under Canopy 30 0.4 W/ft2 12 <br /> Total Allowed Tradable+Site Allowance Watts: 762 <br /> Tradable Proposed Lighting Wattage NOTE 2 <br /> Number of Watts per Watts <br /> Tradable Surface Fixture Description NOTE 3,4 Fixtures Fixture NOTE 5 Proposed <br /> Entry Canopies LED Canopy Light 3 17 51 <br /> Total proposed tradable watts may not exceed the sum of total allowed tradable Total Proposed Tradable Watts: 51 <br /> watts plus the base site allowance. Any base site allowance not needed to make <br /> tradable watts comply can be applied to individual non-tradable categories. <br /> Non-Tradable Maximum Allowed Lighting Wattage N"'t' Site Allowance Remaining: 750 <br /> Area(ft2),perimeter(If) Allowed Watts Allowed Watts <br /> Non-Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) <br /> Non-Tradable Proposed Lighting Wattage NOTE 2 <br /> Number of Watts per Watts <br /> Non-Tradable Surface Fixture Description NOTE 3,4 Fixtures Fixture NOTE 5 Proposed <br /> Non-tradable proposed watts may not exceed allowed watts for any individual Non-Tradable Watts Exceeding LPA: 0 <br /> surface unless the total excess watts for all non-tradable surfaces are less than the <br /> remaining site allowance. Remaining Site Allowance: 750 <br /> Exterior Lighting COMPLIES WITH MAX. ALLOWANCE <br /> Note 1-List all unique exterior sufaces per Table C405.5.2(2)that occur in the project scope.Select exterior surface categories from drop <br /> down menu. <br /> Note 2-List all proposed lighting fixtures including existing-to-remain fixtures. <br /> Note 3-For proposed Fixture Description,indicate fixture type,lamp type,number of lamps in the fixture,and ballast type(if applicable). <br /> Note 4-Existing-to-remain fixtures shall be included in the Tradable and Non-Tradable Proposed Lighting Wattage tables in the same manner <br /> as new fixtures.Identify as existing in fixture description. <br /> Note 5-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For <br /> luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage).For low <br /> voltage lighting,enter the wattage of the transformer. <br /> ' 1 <br />