2201 100TH ST SW AD SYSTEMS 2022-03-07

Lighting, Motor, and Electrical Permit Checklist, Pg. 3 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: AD Systems Warehouse Addition Date 9/5/2017 The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Washington State Energy Code,Commercial Provisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes INTERIOR LIGHTING POWER&EFFICACY Include all luminaires in lighting fixture schedule;indicate fixture types,lamps,ballasts,and manufacturer's rated watts per fixture; Identify spaces eligible for lighting power exemption on plans C405.4.1 Total connected and in compliance forms;indicate the exception applied; Yes C405.4.1 interior lighting C405.4.2 power Identify lighting equipment eligible for lighting power exemption in fixture schedule and in compliance forms;indicate the exception applied; Indicate that exempt lighting equipment is in addition to general area lighting and is controlled independently Yes C405.3 Exit signs Indicate location of exit signs on plans and rated watts per fixture in lighting fixture schedule(maximum 5 watts per fixture) If high efficacy exception is applied to permanently installed Lighting in dwelling lighting fixtures in dwelling units,indicate in lighting fixture NA C405.1 schedule if lamps in fixtures are high efficacy per R404.1. units-lamp efficacy Calculate percentage of fixtures with high efficacy lamps in project(min 75%to comply with exception). Reduced lighting For project with dwelling units,to comply with additional power density- efficiency package option indicate in lighting fixture schedule if NA C406.3 lamps in fixtures have efficacy rating of 60 lumens per watt or dwelling unit lamp more.Calculate percentage of fixtures with lamps that have efficacy this efficacy rating(min 95%to comply with option). Lighting Power Calculation-Indicate compliance path taken Building Area Complete required compliance forms—proposed wattage per Yes C405.4.2.1 building area does not exceed maximum allowed wattage per Method building area.Identify locations of building areas on plans Complete required compliance forms—total proposed wattage NA C405.4.2.2 Space-By-Space does not exceed maximum allowed wattage.Identify locations Method of space types on plans,including retail display areas,lobby art &exhibit display areas,and ceiling heights as applicable To comply with additional efficiency package option, Reduced lighting demonstrate in compliance forms that total connected interior NA C406.3 lighting wattage is 75%less than the total maximum allowed power density lighting wattage via Building Area Method or Space-By-Space Method EXTERIOR LIGHTING POWER&EFFICACY Include all luminaires in lighting fixture schedule;indicate fixture types,lamps,ballasts,and manufacturer's rated watts per fixture; Total connected Identify exterior applications eligible for lighting power NA C405.5.2 exterior lighting exemption on plans and in compliance forms;indicate power exception applied; Indicate that exempt exterior lighting is controlled independently from non-exempt exterior lighting;include exception claimed for each fixture or group of fixtures under exception category NA Table Exterior lighting zone Indicate building exterior lighting zone as defined by the AHJ C405.5.2(1) Exterior building For building grounds fixtures rated at greater than 100 watts NA C405.5.1 that are complying based on efficacy,indicate rated lamp grounds lighting efficacy(in lumens per watt)in fixture schedule Exterior lighting Complete required compliance form—proposed wattage for NA C405.5.2 exterior lighting plus base site allowed does not exceed power calculations maximum allowed