5103 RUCKER AVE 2022-03-23 - Laserfiche WebLink

Table R402.1.1 Footnotes F6rSl: 1 foot .=304.8 mm, ci .=conti s insulation, int .= intermediate framing. aR-values are minimums. U-factors ana�HGCare maximums. When insulation isinstal le in a cavity which is less than the label or design thickness of the insulation, the compressed R-value of the insulation from Appendix Table A101.4 shall not be less than the R-valuespecified in the table. b The fenestration U-factor column excludes skylights. The SHGCcolumn applies to all glazed fenestration. c "10/15/21.+TB" means R-10 continuous insulation on the exterior of the wall, or R-15 on the continuous insulation on the interior of the wall, or R-21 cavity insulation plus a thermal break between the slab and the basement wall at the interior of the basement wall. "10/15/21.+TB" shall be permitted to be met with R-13 cavity insulation on the interior of the basement wall plus R-5 continuous insulation on the! nterior or exterior of the wall. "10/13" means R- 10 continuous insulation on the interior or exterior of the home or R-13 cavity insulation at the interior of the basement wall. "TB" means thermal break between floor slab and basement wall. d R-10 continuous insulation is required under heated slab on grade floors. See 11402.2.9.1. eThere are no SHGC requirements in the Marine Zone. f Reserved. g Reserved. h Reserved. i The second R-value applies when more than half the insulation is on the interior of the mass wall. i Reserved. k For single rafter-orjoist-vaulted ceilings, the insulation may be reduced to R-38. I Reserved. m Int. (intermediate framing) denotes standard framing 16 inches on center with headers insulated with a minimum of R-10 insulation. Table R402.1.3 Footnote a Nonfenestration U-factors shall be obtained from measurement, calculation or an approved source or as specified in Section R402.1.3.