1528 GRAND AVE 2022-04-01 - Laserfiche WebLink

• GeoTest Services, Inc. Report Date 7/17/2019 Anderson Residence-Everett, Washington GTS Project No.19-0384 Floor Support Conventional slab-on-grade floor construction is feasible for the planned site improvements. Floor slabs may be supported on properly prepared native subgrade or on properly placed and compacted structural fill placed over properly prepared native soil. Prior to placement of the structural fill, the native soil should be proof- rolled as recommended in the Site Preparation and Earthworksection of this report. GTS recommends that interior concrete slab-on-grade floors be underlain with at least 6 inches of clean, compacted, free-draining gravel. The gravel should contain less than 3 percent passing the U.S. Standard No. 200 sieve (based on a wet sieve analysis of that portion passing the U.S. Standard No. 4 sieve). The purpose of this gravel layer is to provide uniform support for the slab, provide a capillary break, and act as a drainage layer. To help reduce the potential for water vapor migration through floor slabs, a continuous 10-mil minimum thick polyethylene sheet with tape- sealed joints should be installed below the slab to serve as an impermeable vapor barrier. The vapor barrier should be installed and sealed in accordance with the manufacturer's instructions. The American Concrete Institute (ACI) guidelines suggest that the slab may either be poured directly on the vapor barrier or on a granular curing layer placed over the vapor barrier depending on construction conditions. GTS recommends that the architect or structural engineer specify if a curing layer should be used. If moisture control within the building is critical, we recommend a representative of GTS observe the vapor barrier to confirm that joints and penetrations have been properly sealed. Exterior concrete slabs-on-grade, such as sidewalks, may be supported directly on undisturbed native soil or on properly placed and compacted structural fill; however, long-term performance will be enhanced if exterior slabs are placed on a layer of clean, durable, well-draining granular material. Foundation and Site Drainage Positive surface gradients should be provided adjacent to the proposed building to direct surface water away from the building and toward suitable drainage facilities. Roof drainage should not be introduced into the perimeter footing drains but should be separately discharged directly to the stormwater collection system or similar municipality-approved outlet. Pavement and sidewalk areas, if present, should be sloped and drainage gradients should be maintained to carry surface water away from the building towards an approved stormwater collection system. Surface water should not be allowed to pond and soak into the ground surface near buildings or - 11