4201 RUCKER AVE COMMUNITY HEALTH CENTER 2022-10-07

Mechanical Requirements List, pg 13 of 25 2018 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1 -- Administered by©2022 NEEA,All rights reserved The following information is necessary to check a mechanical permit application for compliance with the mechanical systems and equipment requirements in the Washington State Energy Code,Commercial Provisions. For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com YES C403.10.1.1 :Duct construction Indicate on plans that all ductwork is M001 C403.10.2 constructed and sealed per IMC YES For outdoor air ductwork,also indicate on plans that ductwork meets air leakage requirements per C402.5 and vapor retarder requirements per the IBC YES C403.10.2.1 Duct pressure Identify location of low,medium and high M201,M202 C403.10.2.2 classifications pressure ductwork on plans C403.10.2.3 NA C403.10.2.3 High pressure duct Indicate high pressure duct leakage testing leakage test requirements on plans;provide test results to jurisdiction when completed YES C403.10.1.1 Duct insulation For outdoor air ductwork located within M001 C403.10.1.2 conditioned space(upstream or downstream of shutoff damper),identify climate zone and indicate ductwork insulation R-value per Table C403.10.1.1 on plans;or exception applied YES For supply and return air ductwork located M001 within unconditioned space or outdoors, identify climate zone and indicate ductwork insulation R-value per Table C403.10.1.2 on plans;or exception applied YES For supply air ductwork located within M001 conditioned space,identify on plans if design supply air temperature is<55°F or>105°F; indicate ductwork insulation R-value per Table C403.10.1.2 on plans;or exception applied YES For return and exhaust air ductwork located M001 within conditioned space(upstream of the shutoff damper)and downstream of an energy recovery media,indicate ductwork insulation R-value per Table C403.10.1.2;or exception applied YES For exhaust and relief air ductwork located M001 within conditioned space and downstream of the shutoff damper,indicate ductwork insulation R-value per Table C403.10.1.2;or exception applied NA C403.10.1.1 Shaft and plenum For outdoor air shafts and plenums,indicate C402.1.3 insulation on plans that the R-value of insulation on these elements complies with Table C402.1.3 for steel-framed walls PIPING C403.10.3 Piping insulation Indicate design temperature range of fluid conveyed in piping and thickness of insulation (in inches)on hydronic piping plans;or exception applied C403.10.3.1 Protection of piping Indicate method of protection of pipe insulation insulation from damage/degredation on hydronic piping plans P3ge+412a. \ l 'L/