2702 BROADWAY 2022-12-30 - Laserfiche WebLink

Exterior Lighting LTG-EXT 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised July 2016 Project Title: KFC-Everett Date 10/10/2 019 Exterior Lighting For Building Department Use o Zone 1 Q Zone 2 0 Zone 3 QQ Zone 4 Zone Table C405.5.2(1) Specified by jurisdiction. Zone selection required to enable LTG-EXT form Calculation Area O O Addition- 0 Addition stand alone +existing o Alteration with<50%ext. ® Alteration with z 50%ext. wattage replaced wattage replaced Building Grounds ❑ Efficacy>80 lumens/watt ❑ Exemptio Applies to luminaires> 100 Watts ❑ Controlled by motion sensor Tradable Maximum Allowed Lighting Wattage NOTE 1 Base Site Allowance: 1300 Area(ft`),perimeter(If) Allowed watts Allowed watts Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) Total Allowed Tradable+Site Allowance Watts: 1300 Tradable Proposed Lighting Wattage NOTE 2 Number of Watts per Watts Tradable Surface Fixture Description NOTE 3,a Fixtures Fixture NOTE 5 Proposed • Total proposed tradable watts may not exceed the sum of total allowed tradable Total Proposed Tradable Watts: watts plus the base site allowance. Any base site allowance not needed to make tradable watts comply can be applied to individual non-tradable categories. Non-Tradable Maximum Allowed Lighting Wattage NOTE Site Allowance Remaining: 1300 Area(ft2),perimeter(If) Allowed Watts Allowed Watts Non-Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) Bldg.Facade above grade wall 22 0.2 W/ft2 5 Non-Tradable Proposed Lighting Wattage NOTE 2 Number of Watts per Watts Non-Tradable Surface Fixture Description NOTE 3,a Fixtures Fixture NOTE 5 Proposed Bldg.Façade Single Array LED Flood Light 19 24 456 Bldg.Façade Single Array LED flood light 3 31 93 Non-tradable proposed watts may not exceed allowed watts for any individual Non-Tradable Watts Exceeding LPA: 544 surface unless the total excess watts for all non-tradable surfaces are less than the remaining site allowance. Remaining Site Allowance: 756 Exterior Lighting COMPLIES WITH MAX. ALLOWANCE Note 1-List all unique exterior sufaces per Table C405.5.2(2)that occur in the project scope.Select exterior surface categories from drop down menu. Note 2-List all proposed lighting fixtures including existing-to-remain fixtures. Note 3-For proposed Fixture Description,indicate fixture type,lamp type,number of lamps in the fixture,and ballast type(if applicable). Note 4-Existing-to-remain fixtures shall be included in the Tradable and Non-Tradable Proposed Lighting Wattage tables in the same manner as new fixtures.Identify as existing in fixture description. Note 5-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage).For low voltage lighting,enter the wattage of the transformer.