IMCO General Construction 12/13/2022

City of Everett 00 72 00 - 7 Water Filter Plant Portal 4 Improvements WO# 3755 2.2. DIVISION OF SPECIFICATIONS AND DRAWINGS ' Specifications and Drawings are divided into groups for convenience. These divisions are not for the purpose of apportioning Work or responsibility for Work among Subcontractors, Suppliers and manufacturers. The Contractor is responsible for all Work shown or described,regardless of location(s) ' in the Contract Documents. 2.3. DISCREPANCIES IN SPECIFICATIONS AND DRAWINGS 2.3.1. Errors and Omissions If the Contractor,in the course of the Work,becomes aware of any errors or omissions in the Contract Documents or in the Owner's field work,he or she shall immediately inform the Owner's Representative in writing. The Owner's Representative will promptly review the matter and if he or she finds an error or omission has been made,then he or she will determine the corrective actions and advise the Contractor accordingly. If the corrective work associated with an error or omission significantly increases or ' decreases the amount of Work called for in the Contract,the Owner will issue an appropriate Change Order. After discovery by the Contractor of an error or omission,related work performed by the Contractor shall be done at its risk unless authorized by the Owner's Representative and approved by the Owner. Omissions from the Drawings or Specifications or the misdescription of details of Work that are manifestly necessary to carry out the intent of the Drawings and Specifications,or that are customarily performed,shall not relieve the Contractor from performing such omitted or misdescribed details of the Work,but they shall be performed as if fully and correctly set forth and described in the Drawings and Specifications. 2.3.2. Conflicting Provisions ' Figure dimensions on drawings shall govern over scale dimensions and detail drawings shall govern over general drawings. In the event an item of Work is described differently in two or more locations on the Drawings and in the Specifications,the Contractor shall,upon request of the Owner's Representative, submit in writing to the Owner's Representative the description upon which the Contractor relied in preparing its Bid or laying out the Work. If the Owner's Representative directs the Contractor to perform Work in a manner other than that contemplated by the Contractor in preparing its Bid or laying out the Work,Change Order procedures will be followed. In this event,the Contractor shall submit to the ' Owner's Representative such supporting information,including bidding or layout documents,as may reasonably be necessary for the Owner's Representative to determine whether the Contract Sum is increased,decreased or unchanged by the Change Order. I 1 I 00 72 00 - 7 GENERAL CONDITIONS