Laserfiche WebLink
PRODUCT INFORMATION <br /> Chemical Base Thermoplastic PVC membrane containing ultraviolet light stabilizers,flame <br /> retardant and polyester scrim reinforcement with a unique lacquer coating <br /> on the top surface. <br /> Recycled Content 9%Pre-consumer, 1%Post-consumer <br /> Reinforcing Material Polyester <br /> Packaging 60 mil(1.5 mm)Membrane <br /> 10 ft x 100 ft(3 m x 30 m) roll,343 lbs(156 kg) per roll, <br /> 8 rolls per pallet <br /> 5 ft x 100 ft(1.5 m x 30 m) roll, 172 lbs(78 kg) per roll, <br /> 12 rolls per pallet <br /> Appearance/Color • Top:White, Reflective Gray,and Tan <br /> • Bottom:Gray <br /> Shelf Life N/A <br /> Storage Conditions Store rolls on pallets and fully protected from the weather with clean canvas <br /> tarpaulins. Unvented polyethylene tarpaulins are not accepted due to the <br /> accumulation of moisture beneath the tarpaulin in certain weather <br /> conditions that may affect the ease of membrane weldability. <br /> Overall Thickness 60 mil (1.5 mm), nominal (ASTM D-751) <br /> 45 mil (ASTM Type III D-4434 Spec.Requirement) <br /> Thickness Above Scrim 24 mil (ASTM D-7635) <br /> 16 mil (ASTM Type III D-4434 Spec. Requirement) <br /> TECHNICAL INFORMATION <br /> Resistance to Static Puncture Pass (ASTM D-5602) <br /> 33 Ibf(15 kg) (ASTM Type III D-4434 Spec.Requirement) <br /> Resistance to Dynamic Puncture Pass (ASTM D-5635) <br /> 14.7 ft-Ibf(20 J) (ASTM Type III D-4434 Spec. Requirement) <br /> Tensile Strength 303 Ibf(1348 N) (ASTM D-751) <br /> 200 Ibf(890 N) (ASTM Type III D-4434 Spec. Requirement) <br /> Elongation at Break 20&20%MD&CMD' (ASTM D-751) <br /> 15& 15%MD&CMD' (ASTM Type III D-4434 Spec. Requirement) <br /> 1 MD=Machine Direction,CMD=Cross Machine Direction. <br /> Linear Dimensional Change 0,24% (ASTM D-1204) <br /> 0.5% (ASTM Type III D-4434 Spec.Requirement) <br /> Tear Strength 45 Ibf(200 N) (ASTM D-751) <br /> 45 Ibf(200 N) (ASTM Type III D-4434 Spec.Requirement) <br /> Seam Strength Pass (ASTM D-751) <br /> 75%of origina12 (ASTM Type III D-4434 Spec. Requirement) <br /> z Failure occurs through membrane rupture not seam failure. <br /> Low Temperature Bend Pass (ASTM D-2136) <br /> Pass-40°F(-40°C) (ASTM Type III D-4434 Spec.Requirement) <br /> Product Data Sheet <br /> Sikaplan®Fastened-60 EnergySmart <br /> December 2020,Version 04.01 <br /> 020905011050153002 <br /> BUILDING TRUST <br /> 2/4 <br />