3402 WAVE DR 2023-01-18 - Laserfiche WebLink

RESIDENTIAL PHOTOVOLTAIC PERMIT APPLICATION (Page 1 of 2) CITY OF EVERETT PERMIT SERVICES EVERETT 3200 CEDAR STREET, EVERETT,WA 98201 WASHINGTON (P)425-257-8810 1 FAX 425-257-8857 1 (E)everetteps@everettwa.gov I www.everettwa.gov/permits PROJECT SITE INFORMATION PROJECT ADDRESS: 3402 Wave Drive PARCEL M 00571700600500 BUILDING TYPE: s❑ SFR-DETACHED ❑SFR-ATTACHED/TOWNHOUSE ❑ DUPLEX CONTACT INFORMATION OWNER NAME: Timothy Walsh CONTRACTOR NAME: Blossom Solar CONTRACTOR LIC.#(REQUIRED):BLOSSSL823M7 CITY OF EVERETT BUSINESS LIC.#(REQUIRED): 57621 PRIMARY CONTACT: ❑ OWNER D CONTRACTOR ❑ OTHER(Please Specify) CONTACT NAME: I CONTACT PHONE: (425)610-7067 Madison Martinez ICONTACT EMAIL: office@blossomsolar.com SOLAR PANEL APPLICATION INFORMATION PV SYSTEM DESCRIPTION (include manufacturer and model,#of PV modules and inverters): 10.73 kW qrid tied roof mounted solar system with twenty-nine (29) Silfab SIL-370-HC panels and twenty-nine (29) Enphase IQ7PLUS-72-2-US micro inverters. BUILDING PERMIT CHECKLIST DETERMINE IF YOUR PROJECT QUALIFIES FOR AN OVER-THE-COUNTER BUILDING PERMIT: If you answer yes to all of the below questions, the project qualifies for an over-the-counter building permit. YES NO 1. PV system is designed and proposed for a detached one-or two-family dwelling or townhouse not more than three stories above grade or detached accessory structure that is code compliant to setbacks and height, or code allows 0 ❑ expansion of nonconformity for solar modules. [IRC 101.2] 2. Modules on pitched roofs do not exceed the highest point of the roof unless approved by the local jurisdition. s❑ ❑ 3. Rooftop is made from lightweight material such as a single layer of composition shingles, metal roofing, lightweight F1 ❑ masonry, or cedar shingles. 4. The installation shall comply with the manufacturer's instructions. [IRC M2302.2] ✓❑ ❑ 5. The installation shall meet the requirements of NFPA 70 National Electric Code, and all required electrical permit(s) must ❑ be obtained from the Authority having Jurisdiction to administer the electrical code. [IRC M2302.2] 6. The installation shall meet the requiremetns of the International Fire Code as amended by WA State. [IRC M2302.2] ✓❑ 7. The PV system is designed for the wind speed of the local area, and will be installed per the manufacturer's ❑ specifications. [IRC M2302.2.1(1)] 8. The ground snow load does not exceed 70 pounds per square foot. [IRC M2302.2.1(1)] ✓❑ ❑ 9. The total dead load of modules, supports, mountings, raceways, and all other appurtenances weigh no more than four El per square foot. [IRC M2302.2.1(3)]. Enter total dead load of system (lbs/sq.ft.):2.5 10. To address uplift, modules are mounted no higher than 18"above the surface of the roofing to which they are affixed. ❑ [IRC M2302.2.1(4)] 11. Supports for solar modules are installed to spread the dead load across as many roof-framing members as needed to ❑ ensure that no point load exceeds fifty(50) pounds. [IRC M2302.2.1(5)] 12. The photovoltaic modules and supporting structure shall be constructed of noncombustible materials or fire-retardant F1 ❑ treated wood equivalent to that required for the roof construction. [IRC M2302.2.1] 13. Roof and wall penetrations shall be flashed and sealed to prevent entry of water, rodents, and insects. [IRC M2302.2.2] ✓❑ 14. PV modules are listed and laveled with a fire classification in accordance with UL 1703. [IRC M2302.2.3] ✓❑ ❑ Comments: PLEASE FILL OUT A CITY OF EVERETT BUILDING PERMIT APPLICATION IF YOU QUALIFY FOR AN OTC BUILDING PERMIT. City of Everett Official Use Only ASSSSOCIATED BUILDING PERMIT# Continue on to Page 2 of Application `-' (Revised 9/30/2016)