Laserfiche WebLink
Internal QSplice Installation <br /> ■ The internal QSplice is a floating splice, no attachments -- <br /> necessary. <br /> ■ To join any rail using the Internal QSplice,join the rail sections <br /> by sliding the splice into the end of the rail until the rivet head <br /> comes into contact with the end of the rail. <br /> ■ Slide the other rail onto the splice until the end of the rail <br /> comes into contact with the rivet head. Image 5.2.6 <br /> ■ When re-installing the QRail Internal QSplices, insert the <br /> splice backwards for optimal performance. <br /> NOTE! <br /> To allow for thermal expansion/contraction, <br /> spliced rail lengths should not exceed 45 feet <br /> without a thermal break of 1/2 in. or more. Do Image 5.2.7 <br /> not install modules over this thermal break. <br /> The outside edge of the Image 5.2.8 <br /> QClick must be installed <br /> Aat least 1/2" from end or <br /> rail at a splice location. <br /> DANGER <br /> I m age 5.2.9 <br /> Spliced rails must have more than one <br /> ' support on both sides of the splice. <br /> • Splices cannot be used in cantilever <br /> areas. <br /> CAUTION <br /> Image 5.2.10 <br /> B1 7.2.3-46 19 Jul-2019, Rev 4.2 <br />