Laserfiche WebLink
1 <br /> 1 1) The data shown is representative of laboratory test 28 day cured samples at 50% <br /> 2 humidity. 1 <br /> 3 2) Test sample must be prepared by overlaying 1/4" (6mm) of product on 12.5mm HMA <br /> 4 sample. , <br /> 5 3) A SRI of greater than 29 can be obtained by using pigments or changing the color <br /> 6 index of the aggregate. It is not applicable where color pigments are requested. <br /> 7 4) Only applicable for projects where a LEED certification credit is a requirement of the <br /> 8 surfacing or where a reflective surfacing is specified. <br /> 9 5) Required to provide balance between flexibility, minimal permeability and therefore I <br /> 10 maximum durability. <br /> 11 6) Use the same loading rate as for the ASTM C-109 test above. <br /> 12 7) Quality assurance tests for site I <br /> 13 <br /> 14 8-26.2(2) Chemical Admixtures/Pigments <br /> 15 <br /> 16 Any chemical admixtures and/or color pigments used, the dosage rates and the conditions <br /> 17 for use in the PCSS shall be approved by the manufacturer. <br /> 1811 <br /> 19 <br /> 20 <br /> 21 <br /> I <br /> 22 8-26.2(3) Delivery, Storage and Handling <br /> 23 The material shall be delivered to site in weatherproof containers and stored in a covered <br /> 24 and ventilated location. <br /> 25 <br /> 26 8-26.2(4) Equipment <br /> 27 The equipment to be used shall be approved by the manufacturer or an approved installer. I <br /> 28 The installer shall demonstrate that the equipment shall be capable of handling materials, <br /> 29 performing the work, maintaining proper material temperature, maintaining the minimum <br /> 30 level of required productivity, and producing a product of the specified quality and be 1 <br /> 31 maintained in good mechanical condition. The contractor shall also provide sufficient <br /> 32 equipment to enable the prosecution of the work in accordance with the project schedule <br /> 33 and completion of the work in the specified time. <br /> 34 <br /> 35 8-26.2(5) Material Handling Equipment <br /> 36 The equipment shall be capable of handling and transferring the dry materials and <br /> 37 liquids to the approved mixer without causing spillage, segregation, or contamination. I <br /> 38 <br /> 39 8-26.3 Construction Requirements <br /> 40 <br /> 41 8-26.3(1) Weather limitations <br /> 42 <br /> 43 A. Required Conditions I <br /> 44 <br /> 45 PCSS shall only be placed when all of the following conditions are met: <br /> 46 • The pavement surface is dry. <br /> 47 • Ambient and substrate temperatures are 50° F (10° C) and rising and <br /> I <br /> FLEMING BICYCLE CORRIDOR 78 <br /> PW 3767 November 15, 2022 <br />