Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group R2, R3 & R4 over 3 stories & all R1 -- Administered by @2022 NEEA, All rights reserved <br />The following information is necessary to check a mechanical permit application for compliance with the mechanical systems and equipment requirements in the <br />Washington State Energy Code, Commercial Provisions. <br />For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />C408.1.2.2 <br />Functional <br />Identify in plans and specifications the <br />performance testing <br />intended operation of all equipment and <br />criteria <br />controls during all modes of operation, <br />including interfacing between new and <br />existing -to -remain systems <br />C408.2.2 <br />Air system and <br />Indicate in plans that air and fluid flow rates <br />hydronic system <br />shall be tested and balanced within the <br />balancing <br />tolerances defined in the specifications; <br />indicate systems shall be balanced in a manner <br />to first minimize throttling losses, then <br />adjusted to meet design flow conditions <br />C408.2.2.1 <br />Air system balancing <br />Indicate devices that provide the capability to <br />devices <br />balance all supply air outlets, zone terminals <br />and air handling equipment requiring system <br />balancing <br />C408.2.2.2 <br />Hydronic system <br />Indicate devices that provide the capability to <br />balancing devices <br />isolate, balance and measure flow across all <br />hydronic equipment requiring system <br />balancing including heating and cooling coils <br />and pumps; or exception applied <br />PROJECT CLOSE OUT DOCUMENTATION <br />YES <br />C103.6 <br />Documentation and <br />Indicate in plans that project close out <br />project close out <br />documentation and training of building <br />submittal <br />operations personnel is required for all <br />requirements <br />mechanical components, equipment and <br />systems governed by this code; indicate close <br />out documentation shall include: record <br />documents, O&M manuals, applicable WSEC <br />mechanical equipment compliance reports and <br />calculations <br />Page 25125 <br />