4319 CRESCENT AVE 2023-05-11 - Laserfiche WebLink

COMPOSITION SHINGLE ilr . , i Locate roof rafters and mark locations on roof. Drill 1/4" pilot holes perpendicular to the roof and back fill with roofing manufacturers' approved sealant. Slide flashing between 1st and 2nd course of shingles, ensuring both that the flashing reaches under the 3rd shingle course and doesn't overhang the downhill shingle course. Line up with pilot hole and insert supplied lag bolt with washer through d flashing. With a 7/16" Socket fully seat lag bolt. Place Cap onto flashing in desired orientation for E/W or N/S rails and rotate 180 degrees until it locks into place. r, D Rail can be installed on either side of FlashFoot2 Cap. For additional details refer to the full FlashFoot2 Installation ............................................. Manual. MOMP Locate rafters and snap vertical and horizontal lines to mark locations of flashings. Drill 1/4" pilot holes, then backfill with an approved sealant. Slide flashing between orqu o 1 st and 2nd course of shingles, ensuring both that the 'b flashing reaches under the 3rd shingle course and doesn't overhang the downhill shingle course. Line up pilot hole with View Port. Press Grip Cap onto flashing in desired orientation for E/W or N/S rails. Insert Lag Bolt with d a Q mechanically bonded washer through flashing. With a 7/16" Socket drive Lag Bolt until fully seated. FlashVue is now installed and ready for IronRidge XR Rails. Attach rails to either side of the open slot using bonding hardware. Level rail at desired height, then torque to 250 in-lbs (21 ft-lbs). When installing Gripcap+ on roofs with undulations greater than 1 inch, install GripCap+ in low points across the array as required. C For additional details refer to the full FlashVue Installation Manual. For additional details on the GripCap+refer to the full GripCap+ Installation Manual.