Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group R2, R3 & R4 over 3 stories & all R1 -- Administered by ©2021 NEEA, All rights reserved <br />The following information is necessary to check a building permit application for compliance with the building envelope requirements in the Washington State <br />Energy Code, Commercial Provisions. <br />For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />YIiS <br />C402.2.1.2 Rooftop HVAC <br />Indicate rooftop HVAC equipment curb <br />A4.01 <br />equipment curbs <br />insulation R-value on roof section <br />YES <br />C103.2 Above/below grade <br />Indicate R-value(s) of cavity/continuous <br />A2.01 <br />C402.2.3 wall insulation <br />insulation on wall sections <br />C402.2.4 <br />YES <br />C303 2 1 <br />Indicate framing materials on wall sections <br />A4.01 <br />YES <br />Indicate method of framing for wood <br />A2.01 <br />construction per A 103.2 (std, int, adv) <br />NA <br />Indicate material density category, wall weight <br />and heat capacity for qualifying mass walls <br />NA <br />For qualifying ASTM C90 masonry walls, <br />indicate loose -fill core insulation material and <br />percentage of cores filled including grouted <br />cores, bond beams, vertical fills, headers and <br />any other grouted cores <br />NA <br />Indicate method of protection of exposed <br />exterior basement/crawlspace wall insulation <br />YES <br />C 103.2 Opaque doors <br />Indicate rated U-factor or R-value (non- <br />A2.01 A <br />C402.4.4 <br />swinging) on wall sections or in door <br />schedules - applies to doors with less than <br />50% glazed area <br />NA <br />C402.4.4 Garage doors <br />Indicate rated U-factor for sectional and tilt - <br />up garage doors on wall sections or in door <br />schedules - applies to garage doors with less <br />than 14% glazed area; all other garage doors <br />shall comply as opaque doors <br />NA <br />C402.2.5 Floor over outdoor or <br />Indicate R-value(s) of cavity/continuous <br />unconditioned space <br />insulation on floor sections <br />insulation <br />Indicate framing material on floor sections <br />Indicate material density category and weight <br />of qualifying mass floors <br />NA <br />C402.2.6 Slab -on -grade floor <br />Indicate R-value of continuous insulation on <br />C303.2.1 insulation <br />wall section or foundation detail <br />l I :S <br />Indicate insulation extends down vertically <br />A4.01 <br />and/or horizontally the required distance from <br />top of slab <br />Indicate method of protection of exposed <br />exterior slab edge insulation <br />N;1 <br />Indicate R-value of continuous insulation on <br />wall section or foundation detail <br />NA <br />Indicate insulation extends down vertically <br />from top of slab and then horizontally under <br />the entire slab <br />N. <br />Indicate method of protection of exposed <br />exterior slab edge insulation <br />