6522 WETMORE AVE 2023-05-31 - Laserfiche WebLink

Table R402.1.1 Footnotes For SI:1 foot.=304.8 mm,ci.=continu insulation,int.=intermediateframing. 110 J a R-values are minimums.U-factors and SHGC are maximums.When insulation is installed in a cavity which is less than the label or design thickness of the insulation,the compressed R-value of the insulation from Appendix Table A101.4 shall not be less than the R-value specified in the table. b The fenestration U-factor column excludes skylights.The SHGC column appliesto all glazed fenestration. c"10/15/21.+TB"means R-10 continuous insulation on the exterior of the wall,or R-15 on the continuous insulation on the interior of the wall,or R-21 cavity insulation plus a thermal break between the slab and the basement wall at the interior of the basement wall."10/15/21.+TB"shall be permitted to be met with R-13 cavity insulation on the interior of the basement wall plus R-5 continuous insulation on the interior or exterior of the wall."10/13"means R- 10 continuous insulation on the interior or exterior of the home or R-13 cavity insulation at the interior of the basement wall."TB"means thermal break between floor slab and basement wall. d R-10 continuous insulation is required under heated slab on gradefloors.See R402.2.9.1. e There are no SHGC requirements in the Marine Zone. f Reserved. g Reserved. h Reserved. i The second R-value applies when more than half the insulation is on the interior of the mass wall. j Reserved. k For single rafter-or joist-vaulted ceilings,the insulation may be reduced to R-38. I Reserved. m Int.(intermediate framing)denotes standard framing 16 inches on center with headers insulated with a minimum of R-10 insulation. Table R402.1.3 Footnote a Nonfenestration U-factors shall be obtained from measurement,calculation or an approved source or as specified in Section R402.1.3.