Laserfiche WebLink
1_9 <br /> Lighting Summary, cont. LTG-SUM <br /> 2015 Washington State Energy Code Compliance Forms for Commercial Buildings induding R2,R3,R4 over 3 stories and all R1Revised Nov 2017 <br /> 'Project Title: Sea Mar Everett Clinic bate 4/8/2020 <br /> Change of Space Use 0 Existing interior lighting systems in areas under-going a change in space use are upgraded to <br /> comply with LPAs for the new space types per Tables C405.4.2(1)or C405.4.2(2). <br /> Identify interior spaces requiring LPD upgrade to the current Code in Proposed Lighting Wattage <br /> table in LTG-INT-BLD or LTG-INT-SPACE form. <br /> Interior and Exterior Lighting Power Interior lighting Parking garage Exterior lighting <br /> Lighting Alterations 50%or more of existing are replaced 0 ! 0 0 <br /> Select all Lighting Power and Lighting <br /> Control elements that apply to the scope Less than 50%of existing are replaced 0 0 0 <br /> ofthe retrofit project If project includes a .__...._...._......_.___..._____.._.._...__....__...__...._.._...___._.___._._._._.___..__.._....._...__.._.____.._...___._ —.._____...__..._..._......__.__._._.___.--.----..._.........__....._.__..._.._. <br /> combination of spaces where less than Lamp and/or ballast replacement only <br /> 50%of the existing fixtures are replaced —existing total wattage not increased 0 0 0 <br /> in <br /> are replaced in then some spaces,and or more of the 50%or more replaced-Total lighting power of new+existing-to-remain fixtures shall comply with <br /> fixtures others, total LPA per Sections C405.4.2 and C405.5.2. Include new+existing-to-remain fixtures in <br /> provide separate lighting power <br /> compliance forms for the two retrofit Proposed Lighting Wattage table in LTG-INT-BLD,LTG-INT-SPACE or LTG-EXT form. <br /> conditions.Spaces undergoing the same Less than 50%replaced-Total lighting power of new+existing-to-remain fixtures shall not exceed <br /> type of retrofit may be combined into one the total lighting power prior to alteration. Include new+existing-to-remain fixtures in the Proposed <br /> lighting power compliance form. Lighting Wattage table in LTG-INT-BLD,LTG-INT-SPACE or LTG-EXT form. <br /> 50%threshold applies to numberof luminaires for interior spaces and parking garages,and total <br /> Refer to Section C503.6 for additional installed wattage for exterior luminaires. <br /> requirements. <br /> Lighting Controls Interior lighting Parking garage Exterior lighting <br /> All alteration lighting controls shall be New wiring installed to serve added <br /> commissioned perC408.3. fixtures and/or fixtures relocated to ® 0 0 <br /> new circuits) <br /> New or moved lighting panel 0 0 0 <br /> Interior space is reconfigured - — 0 <br /> luminaires unchanged or relocated <br /> New wiring or circuit-For interior lighting,provide required manual controls per C405.2.3, <br /> occupancy sensor controls per C405.2.1,daylight responsive controls per C405.2.4 and application <br /> 0 No changes are being made to specific lighting controls per C405.2.5.For exterior lighting,provide required controls per C405.2.7. <br /> the interior or exterior lighting New or moved panel-Provide all applicable lighting controls as noted for New Wiring and automatic <br /> systems and existing space time switch controls per C405.2.2. <br /> uses and configuration are not Reconfigured interior space-Provide all required lighting controls that apply to a new interior <br /> changed space.Application specific lighting control provisions per C405.2.5 do not apply to reconfigured <br />