Laserfiche WebLink
DANGER HIGH VOLTAGE: DlsconneM power batons attempting maintenance or repair. <br />Maintaining Your Heater's Appearance <br />Fingerprints or other marks left on the optional plated surface may become etched in place if they are not <br />wiped dean prior to turning the heater on. Clean the plated surfaces with denatured alcohol and a soft <br />cloth (w0h the heater cool). Other cleaners may leave a film that may become etched Into the surface. <br />Accent Liaht Rea/acement <br />The accent lights in your heater provide additional lighting. The bulbs will bum out over time. To replace, <br />follow the directions below: <br />1. Shut off gas to the heater and let it cool for 15 minutes. <br />2. Remove the glass (see page 22) and media. <br />3. Replace the halogen bulbs with the following bulbs: <br />NOTE: Take care to not touch the bulbs with your fingers— use foam packing or a paper towel to <br />handle the bulbs: <br />35 Waft 120 Volt T4 Halogen Bulb (GT6.35 Base) <br />Upper Accent Lights <br />The upper accent light can be accessed by removing the 4 screws with a''/0 nut driver, as shown below. <br />The upper accent light assembly drops down to expose the accent light. <br />®When replacing the assembly, carefully insert the wiring into this cavity to ensure the wiring is <br />nalpinched. <br />The upper accent light may now be accessed. <br />0 Travis Industries 4/26c2023 -1521 430 EG GSR <br />