Laserfiche WebLink
Install the LP pilot onfice following the directions below. <br />(a) Use a 7/16" open-end wrench to remove the pilot hood. <br />(b) Remove and discard the Natural Gas (NG) orifice. Place fire LP orifice in the pilot assembly then <br />replace the pilot hood, tightening the pilot hood until it is snug (do not over -lighten). <br />p <br />Natural Gas Orifice = .018N I -I <br />LP (Propane) Onfos = .014LP c� <br />O <br />7/i6"Wrench <br />r <br />F3 <br />7. Replace the firebox components. Restore the fireplace to the correct configuration. Install the firebacks <br />before re -installing the burner. <br />B. Access the stepper motor (shown below). The stepper molar (adjustable regulator) has an installation <br />sheet included with it- make sure to follow all of the directions. Disconnect the wining from the stepper <br />motor. Remove the stock stepper motor and replace with the LP version. - MAKE SURE 1T IS <br />CORRECTLY ORIENTED. Secure using the screws included with the motor - tighten to 25 Lb -inches. <br />Leak test this area after installation to verify proper installation. Re -attach the wiring. <br />9. Restore the appliance to the correct configuration. Make the gas line connection, bleed the gas line (if <br />applicable), start the healer, and thoroughly leak -test all gas connections and the gas control valve. <br />0 Travis Industries 4Y16Y1023 -1521 430 EG GSR2 <br />