Laserfiche WebLink
Installation Model: FSH-2, FSH-2A-99 <br /> EMEMEW7 L <br /> This section summarizes procedures necessary for proper equipment installation. To help avoid personal injury or <br /> equipment damage, be sure to adhere to all of these recommended procedures. <br /> Installation is the Purchaser's responsibility. It is advisable to engage the services of a professional commercial <br /> kitchen equipment specialist, licensed electrician, and qualified HVAC contractor to assist with the details of <br /> installation. Call Giles Technical Support@ 800.554.4537, if assistance is required. <br /> IMPORTANT!! <br /> Before installing the GILES Recirculating/Ventless Hood system ensure that, A). all necessary approvals from local <br /> code authorities have been obtained, B). the fryer to be used with the hood is within the hood's listing <br /> limitations, as stated in Section 2.04, and C). the installation site complies with the specific requirements and <br /> limitations outlined in the GFSE Recirculating/Ventless Hood Approval Letter(HAL). The HAL is available for <br /> review or download at www.gfse.com under the SUPPORT tab in VENTLESS DOCUMENTS. <br /> To ensure satisfactory hood performance after installation, the intended site MUST comply with minimum <br /> requirements for kitchen size (>300 sq ft), ceiling height, fresh outdoor air make-up, supplemental exhaust <br /> ventilation, clearances, etc. as stipulated in Giles' Hood Approval Letter. <br /> • MAXIMUM of 1 hood per 300 sq ft of commercial kitchen space. <br /> • Fresh outside air make-up must be equal to a MINIMUM of 15 complete room air exchanges per hour. <br /> • Giles makes no representations as to the proper design or layout of an establishment in which the ventless <br /> hood will be used. Further, Giles does not perform site inspections prior to installation of any of its units. <br /> • When operating, the hood produces a sound level of approximately 65 dB. <br /> ACAUTION <br /> • DO NOT ALTER,ADD ATTACHMENTS OR OTHERWISE MODIFY THIS EQUIPMENT. <br /> • Failure to comply with installation requirements as specified by the Giles Hood Approval Letter will void the <br /> factory warranty. <br /> 1. Before unpacking, review dimensions and clearances shown in Section 1.04.1 or 1.04.2, and determine <br /> whether the location selected is suitable. <br /> 2. Keep the unit and the surrounding area free and clear of combustible materials. <br /> 3. Do not obstruct the openings around the exhaust air diverter atop the hood. No minimum clearance (0") is <br /> required between air diverter and the ceiling, but it is advisable to provide some clearance (>3") to make <br /> moving the unit easier should the need arise. <br /> 4. Provide adequate space for future servicing and proper operation. <br /> S. Hood is equipped with adjustable leveling legs. After final positioning, adjust the legs to level the unit, side <br /> to side, front to back and corner to corner. <br /> 6. Before operating, make sure the unit is secured in position and will not move. The front legs of a FSH-2A-99 <br /> Hood have floor plates for securing the unit to the floor. <br /> 5 <br />