2721 WETMORE AVE MARQUEE APARTMENTS 2023-06-28

• • also be included with your resubmittal to address the comments below(handwritten remarks under each comment on this letter are perfectly acceptable).The below listed sheets have redlines. i. Sheet C3.0 ii. Sheet C4.0 3. The comments below were generated from this project's Street Light Reviewer. If you have any questions regarding these comments, please contact Corey Hert with the City of Everett Planning Department(425- 257-8887 or CHert@everettwa.gov). a. There is no existing decorative lighting circuit to splice to. A wire run will need to be shown all the way back to the electrical service. Arrange a meeting with Steve Sawyer,City of Everett Signal Supt,425-328-0643 in the field to determine the location of the service so a branch breaker can be installed and new circuit installed. I u“og. P 012A-1 es) b. The City of Everett no longer provides decorative street lights to downtown developments. The decorative poles including pole sub-assembly, decorative base sub-assembly, and decorative twin arm sub-assembly, and lighting fixtures will need to be provided by the proponent. Powder coating is Everett Green RAL 6012 color. Approved model is Visco VI-EVR9-EVR2-OCT/13'. No GFI receptacle is required. For most current information about other available manufacturers, proponent can contact Lighting Group Northwest, Ken Freed or Julie Jergens,for latest model numbers. Past approved shop drawings are attached. ifJC-4 -?LRPA tD c. Construction note 2 calls for a contractor provided 35' painted steel light pole. This pole will be a "relocation" of the existing aluminum pole removed under construction note 6. The City will store the removed light standard at its Railway Ave Yard and provide the proponent with a new or near-new pole when ready to be installed. The construction note 2 should make reference to this being a relocated aluminum pole with a 12' mast arm and fixture. It will not be painted, but spun aluminum finish like the other poles on the block face. The note 2 should also make reference that the contractor will need to verify anchor bolt dimensions prior to pouring the foundation, because the pole that will be provided by the City may not have the exact same dimensions at the existing pole. The City will retain the old pole for future knock downs, but because it is not in mint condition and would look out of place in a new development,the City will be providing one of superior condition. 3- NC_cRP o'Rt41EP d. The existing Type 2 junction box for the flashing beacon overhead assembly will need to be replaced with a new box with non-slip lid and frame if it does not already have one. A construction note would be added in this case. CcRQ o1E.S7 O3200 Cedar Street © 425.257.8810 O everetteps@everettwa.gov Everett, WA 98201 425.257.8857 fax everettwa.gov/permits Page 2 of 2