Laserfiche WebLink
GeoTest Services, Inc. October 8,2021 <br /> 2405 Hillside Lane, Everett,WA Project No.21-0845 <br /> sommimr�r1 <br /> native soils are not suitable for the conventional infiltration of stormwater.GeoTest recommends <br /> that approaches other than infiltration be considered to address stormwater management on <br /> this project. <br /> Site Preparation and Earthwork <br /> The portions of the site proposed for foundations should be prepared by removing topsoil, <br /> deleterious material, significant accumulations of organics, and loose fill soils (if present). <br /> GeoTest anticipates between 1 and 3 feet of stripping to expose suitable subgrade soils within <br /> native soils in the vicinity of the proposed development. We expect that the thicker depths of fill <br /> will be present near Lots 2 and 4. <br /> Prior to placement of any foundation elements or structural fill, the exposed subgrade under all <br /> areas to be occupied by soil-supported floor slabs, spread, or continuous foundations should be <br /> recompacted to a firm and unyielding condition.Verification of compaction should be performed <br /> by qualified geotechnical personnel. The purpose of this effort is to identify loose or soft soil <br /> deposits so that, if feasible, the soil disturbed during site work can be recompacted. <br /> Proof rolling should be carefully observed by qualified geotechnical personnel. Areas exhibiting <br /> significant deflection, pumping, or over-saturation that cannot be readily compacted should be <br /> overexcavated to firm soil. Overexcavated areas should be backfilled with compacted granular <br /> material placed in accordance with subsequent recommendations for structural fill. During <br /> periods of wet weather, proof rolling could damage the exposed subgrade. Under these <br /> conditions, qualified geotechnical personnel should observe subgrade conditions to determine if <br /> proof rolling is feasible. <br /> Fill and Compaction <br /> Structural fill must be properly placed and compacted. In most cases, suitable, non-organic, <br /> predominantly granular soil may be used for fill material provided the material is properly <br /> moisture conditioned prior to placement and compaction, and the specified degree of <br /> compaction is obtained. Material containing topsoil, wood, trash, organic material, or <br /> construction debris is not suitable for reuse as structural fill and should be properly disposed off- <br /> site or placed in nonstructural areas. <br /> Soils containing more than approximately five percent fines are considered moisture sensitive <br /> and are difficult to compact to a firm and unyielding condition when over the optimum moisture <br /> content by more than approximately two percent. The optimum moisture content is that which <br /> allows the greatest dry density to be achieved at a given level of compactive effort. <br /> 9 <br />