4128 RUCKER AVE SAFEWAY 2023-11-01

Centium ICN-4P16-TLED-N ICN-4P16-TLED-N Brand Name Centium Driver Type T8 LED Electronic Lamp Connection Parallel Input Voltage 120-277V Input Frequency 50/60 Hz Status Active Electrical Specifications Section I - Physical Characteristics 1.1 Driver shall be physically interchangeable with standard electromagnetic or standard electronic ballasts, where applicable. 1.2 Driver shall be provided with integral leads color coded per ANSI C82.11. Section II - Performance Requirements 2.1 Driver shall energize compatible LED lamps within 1 second after mains power is applied. 2.2 Driver shall provide Independent Lamp Operation (ILO) allowing remaining lamp(s) to maintain full light output when one or more lamps fail. 2.3 Driver shall contain auto restart circuitry in order to restart lamps without resetting power. 2.4 Driver shall operate from a 50Hz or 60 Hz AC input source of 120V through 277V with sustained variations of +/- 10% (voltage and frequency). 2.5 Driver shall be high frequency electronic type and operate lamps at frequencies above 42 kHz to avoid interference with infrared devices and eliminate visible flicker. 2.6 Driver shall have a ower Factor of 0.90 or above when operating the maximum rated number of compatible lamps, and 0.88 or above when operating the minimum rated number of compatible lamps. 2.7 Driver input current shall Total Harmonic Distortion (THD) of 10% or less when operating the maximum rated number of compatible lamps and 15% or less when operating the minimum rated number of compatible lamps. 2.8 Driver shall have a Class A sound rating. 2.9 Driver shall have a minimum starting temperature of -130F / -25°C. 2.10 Driver shall tolerate sustained open circuit and short circuit output conditions. 2.11 Driver shall be capable of operating lamps remotely and in tandem for wire lengths up to 20 ft. 2.12 Driver shall be suitable of operation in up to a 450C ambient temperature. Section III - Regulatory Requirements 3.1 Driver shall not contain any Polychlorinated Biphenyl (PCB). 3.2 Driver shall be Underwriters Laboratoriesmecognized, and suitable for Damp and Dry conditions, and CSA Certified where applicable. 3.3 Driver shall comply with ANSI C62.41 Category A Transient protection. 3.4 Driver shall comply with the requirements of the Federal Communication Commission (FCC) rules and regulations, Title 47, CFR part 15, Non -Consumer (Class A) for EMI/RFI (conducted and radiated). 3.5 Driver shall comply with NEMA 410 for in -rush current limits. Section IV - Other 4.1 Driver shall be manufactured in a factory certified to ISO 9001 Quality System Standards. 4.2 Driver shall carry a&W&W.&6warrantyVrom date of manufacture against defects in material and workmanship when operating in a 450C ambient environment or less. The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract.