Laserfiche WebLink
Installation • Qualified Only) <br /> Heating Specifications <br /> Approximate Maximum Heating Capacity(in square feet)*............................................800 to 2,000 Sq. Feet <br /> BTUs..............................................................................................................................11,480 to 41,000 <br /> Burn Rate(Pounds per Hour)***....................................................................................1.4 to 5 <br /> Maximum Burn Time on Low Burn***.............................................................................28 to 50 Hours <br /> HopperCapacity............................................................................................................40 to 70 Pounds <br /> Turn-Down Ratio............................................................................................................71% <br /> Heating capacity will vary depending on the home's floor plan,degree of insulation,and the outside temperature. It is also affected by the fuel <br /> size,quality,and moisture level. <br /> Based on 8,200 BTUs per pound. <br /> * Small pellet size will decrease the stated burn rates and burn times. Differences of plus or minus 20%depending on fuel quality may occur. <br /> c 33.25"(845mm)Min.Fireplace Width <br /> Dimensions 8.375"213mm 3"(77mm)Dia.Exhaust <br /> 21.75"(553mm) <br /> 1.75"(45mm)Dia.Intake <br /> E'� <br /> 11.5,E14.25"(362mm) 293mm <br /> Min.Fireplace Depth 8.375" <br /> U 213mm <br /> Fireplace Opening <br /> R\ <br /> 10"(254mm) 42"(1067mm) \ <br /> Extension Onto Hearth Control Panel <br /> ............................... <br /> Front of Firebox 24.75"(629mm) <br /> (for measuring hearth requirement) <br /> 30.5" e <br /> (775mm) e <br /> 26" e 24"(610mm)Maximum <br /> (661 mm) a Hopper Setting(70 Ib.) <br /> 21"(534mm)Mlnimum <br /> Hopper Setting(40 Ib.) <br /> Electrical Specifications <br /> Electrical Rating......................................................................................................115 Volts, 3 Amps, 60 Hz <br /> Watts during Start-Up Sequence ............................................................................350 (approximately) <br /> Watts during Operation...........................................................................................250 (approximately) <br /> Fuel <br /> This heater is designed and approved for pelletized wood fuel only(all grades). Travis Industries Inc. <br /> recommends using only fuel that is certified by the Pellet Fuels Institute (PFI). <br /> Emissions <br /> This heater meets the 2020 U.S. EPA's emission limits for pellet stoves. Report#0028PN108E Tested to ASTM <br /> E2779-10,ASTM 2515-11, CSA B415.1-10 this heater has been shown to deliver heat at rates ranging from 12,138 to <br /> 41,758 BTU/hr and an emission value of 0.98g/h.BTU/hr <br /> Efficiency <br /> This model was tested for efficiency using method B415.1-10 and was determined to have a weighted <br /> average higher heating Value (HHV) Overall Heating Efficiency (OHE) of 75.6%. Overall efficiency of the <br /> heater may be lower if the heater is operated with the heat exchange blower on low. <br /> ©Travis Industries 11/15/18- 1341 AGP Insert <br />