1520 81ST PL SE 2023-09-14 - Laserfiche WebLink

i Permit Inspections V E R E T T City of Everett WASHINGTON Permit Number: M2211-037 Description:AIR HANDLER AND HEAT PUMP INSTALL Applied: 11/10/2022 Approved: 11/10/2022 Site Address: 1520 81ST PL SE Issued: 11/11/2022 Finaled:8/30/2023 City,State Zip Code: EVERETT,WA 98203 Status: FINALED Applicant:CM AIR PROS LLC(CONST) Parent Permit: Owner:GRISWOLD VANIA&ANTHONY Parent Project: Contractor: CM AIR PROS LLC(CONST) Details: AIR HANDLER AND HEAT PUMP INSTALL SCHEDULED DATE COMPLETED DATE TYPE INSPECTOR RESULT REMARKS 2/24/2023 2/24/2023 MECH 06-FINAL JEFF M RHODE CORRECTION see notes REQUIRED Notes: 2/20/2023 2:47 PM CM AIR PROS LLC(CONST) please call on the way Contact Name:Anthony Griswold Site Address:1520 81ST PL SE Phone:2063800159 e-Mail:anthonyrgriswold@gmail.com -no emergency drain on condensate 307.2.3 Auxiliary and Secondary Drain Systems In addition to the requirements of Section 307.2.1,where damage to any building components could occur as a result of overflow from the equipment primary condensate removal system,one of the following auxiliary protection methods shall be provided for each cooling coil or fuel-fired appliance that produces condensate: An auxiliary drain pan with a separate drain shall be provided under the coils on which condensation will occur.The auxiliary pan drain shall discharge to a conspicuous point of disposal to alert occupants in the event of a stoppage of the primary drain.The pan shall have a minimum depth of 11/2 inches(38 mm),shall be not less than 3 inches(76 mm)larger than the unit,or the coil dimensions in width and length and shall be constructed of corrosion-resistant material.Galvanized sheet steel pans shall have a minimum thickness of not less than 0.0236 inch(0.6010 mm)(No.24 gage). Nonmetallic pans shall have a minimum thickness of not less than 0.0625 inch(1.6 mm). A separate overflow drain line shall be connected to the drain pan provided with the equipment.Such overflow drain shall discharge to a conspicuous point of disposal to alert occupants in the event of a stoppage of the primary drain.The overflow drain line shall connect to the drain pan at a higher level than the primary drain connection. An auxiliary drain pan without a separate drain line shall be provided under the coils on which condensate will occur.Such pan shall be equipped with a water-level detection device conforming to UL 508 that will shut off the equipment served prior to overflow of the pan.The auxiliary drain pan shall be constructed in accordance with Item 1 of this section. A water-level detection device conforming to UL 508 shall be provided that will shut off the equipment served in the event that the primary drain is blocked.The device shall be installed in the primary drain line,the overflow drain line,or in the equipment-supplied drain pan,located at a point higher than the primary drain line connection and below the overflow rim of such pan. I Printed:Wednesday, 30 August, 2023 1 of 2 SUPERION