2405 COLBY AVE 2023-09-14 - Laserfiche WebLink

ISO-X: Isolator module.See DN-2243. NBB-2:Annunciator backbox,2 position. ISO-6: Six fault isolator module.See DN-60844. CLSS GATEWAY AND LICENSABLE FEATURES XP6-C: FlashScan six-circuit supervised control module. See DN- HON-CGW-MBB: CLSS Gateway, pre-installed in a cabinet. See 6924, NON-62034, XP6-MA: FlashScan six-zone interface module; connects intelligent Licenseable features: Individually purchased and downloaded to a alarm system to two-wire conventional detection zone.See 0N-6925. specific panel. XP6-R: FlashScan six-relay(Form-C)control module.See DN-6926. • N16-CAC: Custom Action Button expansion.Adds 8 custom action XP10-M: FlashScan ten-input monitor module.See DN-6923. buttons to an N16 panel(maximum 32 buttons). ENCLOSURES,CHASSIS,AND DRESS PLATES • N16-CLIP: Enables CLIP mode on an N16 panel. CAB-5 Series Enclosure:CPU-N16LD and CPU-N16LND mount in a . N16-GZN:General Zone expansion.Adds 250 general zones to an standard CAB-5 Series enclosure (available in 5 sizes, "A" through N16 panel(maximum 2000 zones). "E"). Backbox and door ordered separately; requires BP-5 battery • N16-LGZ: Logic Zone expansion. Adds 250 logic zones to an N16 plate. See DN-62113. panel(maximum 2000 zones). C5A-M: Chassis for FACP control panel when DVC-EM is used. • N16-NWD: Enables Network Display Mode on an N16 panel to Comes with microphone (accommodates separately ordered hand- emulate NCD's network display capabilities. set), mounting in the first, second, or third row of a CAB-5 series • N16-UZC: Universal Zone Coding,enables UZC for an N16 panel. enclosure(takes one row).Order dress panel DPA-05 separately. NOTE: For other options including compatibility with retrofit equipment, C5A-NW: Audio chassis for mounting DVC, keypad, and two optional refer to the panel's installation manual, the SLC manual, and the Device module cards in a CAB-5 series enclosure. Order dress panel DPA- Compatibility Document. 2A5 to add 2 additional positions on the right. COMMUNICATORS DP-T2A: Dress panel for CAB-5 Series, mounts 10" display and two CCM-ATT-HON:AT&T Cellular module for CLSS gateway ACM-30 annunciators. DP-T2A-CB4: Dress panel for CAB-4 Series, mounts 10" display and CCM-VZ-HON:Verizon Cellular module for CLSS gateway two ACM-30 annunciators. CGW-PT:Telco/POTS Card to mount the CGW-MB. DP-GDIS1: Graphic Annunciator Dress Plate, mounts the 10" graphic HWF2A-COM. LTE/IP Dialer Capture Alarm Communicator display and ONYX Series Annunciators in the top row of a CAB-4 HWF2V-COM. LTE/IP Dialer Capture Alarm Communicator Series cabinet. HW-TG7LAF02. LTE Dialer Capture Alarm Communicator DP-GDIS2: Graphic Annunciator Dress Plate, mounts the 10" graphic display and ONYX Series Annunciators in the second, third or fourth HW-TG7LVF02. LTE Dialer Capture Alarm Communicator row of a CAB-4 Series cabinet. AGENCY LISTINGS AND APPROVALS DP-4A: Dress panel for CAB-5 Series, mounts four ACM-30 The file number(s) below reference the specific listings for the mod- annunciators. ules in this document. In some cases, certain modules or applications DP-4A-CB4: Dress panel for CAB-4 Series, mounts four ACM-30 may not be listed by certain approval agencies, or listing may be in annunciators. process. Consult NOTIFIER for latest listing status. DP-BLN: Blank dress panel. Provides dead-front panel for unused • UL Listed:S635. tiers in a CAB-5 Series enclosure. • FM Approved ABP-1: Blank plate for 1 ACM-30. • CSFM:7165-0028:0516 DPA-2A5: Dress panel for CAB-5 series, mounts DVC-KD/B with two • FDNY:COA#001761. Annunciator positions (when microphone and fire fighter handset well STANDARDS is not used). DPA-05:Audio dress panel for C5A-M, has openings for microphone, The N16 Series complies with the following UL Standards and telephone and keypad. NFPA 72 Fire Alarm Systems requirements: 13P-5: Battery plate, required. • UL 864, 10th edition (Control Units and Accessories for Fire Alarm Systems). NFS-LBB: Battery Box. The NFS-LBB is used to mount up to two . UL 2017(General-Purpose Signaling Devices and Systems). 55 AH batteries. Dimensions: Box:24" (610 mm)wide x 14" (356 mm) UL 2610 (Commercial Premises Security Alarm Units and high x 7.75" (197 mm) deep. Door: 24.125" (613 mm) wide x 14.25" Systems). (362 mm)high;door adds 0.0625" (approx. 1.6 mm)to depth. • NFPA 72 Local (Automatic, Manual, Waterflow, and Sprinkler CHS-CGW:Chassis for mounting the CGW-MBB in a CAB-4 or CAB-5 Supervisory). Series enclosure. • NFPA 72 Central Station (Automatic, Manual, Waterflow, and CHS-ADP: Adapter plate for mounting a CAB-4 chassis in a CAB-5 Sprinkler Supervisory, requires CGW-MBB or HON-CGW-MBB.) Series enclosure. • NFPA 72 Remote Station (Automatic, Manual, Waterflow, and BACKSOXES Sprinkler Supervisory)(requires UL 10th edition listed DACT). BB-100: Backbox for batteries and power supplies. The BB-100 • NFPA 72 Proprietary(Automatic,Manual,Waterflow,and Sprinkler mounts up to two 100 AH batteries and power supply, if needed. 30" Supervisory). Not applicable for FM. (76.20 cm) wide x 25" (63.50 cm) high x 7.5" (19.05 cm) deep; depth • NFPA 72 Emergency Voice/Alarm(requires DVC/DAA/DAA-2) includes door. • NFPA 72 PB (Performance Based Technologies) (Requires CGW- BB-200: Backbox for batteries and power supplies. Holds up to four MBB or HON-CGW-MBB). 100 AH batteries(200 AH capacity)and power supply.30" (76.20 cm) NOTE: Install in accordance with the UL and NFPA standards specified in wide x 36" (91.44 cm) high x 7.5" (19.05 cm) deep; depth includes panel documentation. door. ABB-1: Backbox for ACM-30 annunciator, 1 position. ABB-2: Backbox for ACM-30 annunciator,2 position. DN-62112:E•7/11/2022—Page 5 of 6