Laserfiche WebLink
0 ill 10 of 24 <br /> Friday. July 24, 2020 <br /> 7 <br /> SCOPEi <br /> O F WORK if FOUNDATION SPECIALIST <br /> Crew will install 3" Helical Piles. as well as 3"Concentric Piers, and stabilize home only. Crew will drive piles to a maximum 25' <br /> after there will be a S20 a foot charge per pile. Crew will remove and replace concrete. <br /> L120 is in concurrence with pile layout recommended by R&R provided that the proposed layout is followed as marked and piles are installed <br /> with a maximum pile spacing as indicated below and installed per the attached SSK-01 &SSK-02. <br /> All measurements to be re-taken and confirmed on site prior to construction. Notify L120 before proceeding if the change in the <br /> measurements represented below exceeds+/-10%. <br /> NOTES: <br /> 1. It is acceptable to install piles at the spacing shown with±0'-6"tolerance to allow for unexpected obstructions encountered during pile <br /> installation provided that no two adjacent spans exceed the spacing limitation of 8'-0"o.c. UNO. <br /> 2. End piles are to be placed within 3'-0"from corner as specified below UNO. <br /> LEVEL SUS.\/ E.M <br /> CENTER PILE ON FULL CENTER PILE ON FULL <br /> HT WALL SEGMENT HT WALL SEGMENT <br /> LOCATE PILE <br /> WITHIN 3'-0" <br /> 2 4 52' 6 7 8 FROM CORNER <br /> 1/1 <br /> 1 ': -3/8 -1 1/8 -1 1/8 -1 t18 -1 3/4 g• <br /> LOCATE PILE <br /> WITHIN 1'-0" LOCATE PILE WITHIN 1'-0" .' 1 0 <br /> FROM CORNER FROM DOORNVINDOW <br /> OPENING (2)PILES @ <br /> 8'-0"OC MAX <br /> in <br /> N <br /> i 2 co <br /> tIj , LOCATE PILES UNDER in <br /> i CHIMNEY FTG -1!, <br /> 0 0 -3/8 -1 <br /> 35.5' • <br /> 0 <br /> -3/: <br /> -9- = 3" Helical Pile -•,,, • • <br /> ,: 16.5' <br /> -C?- = 3" Concentric Pier -' <br /> NOTE:L120's scope is limited to the perimeter support systems/continuous footings of the primary structure.All stabilization and replacement efforts of <br /> interior elements,exterior decks,and deck supporting elements are outside of L120's contract and scope and are not addressed in this package.-L120 <br />