113 75TH ST SW 2023-10-19 - Laserfiche WebLink

RESIDENTIAL PHOTOVOLTAIC PERMIT APPLICATION (Page 1 of 2) CITY OF EVERETT PERMIT SERVICES EVERETT SUBMITTAL INSTRUCTIONS:Email application to PermitServices@everettwa.gov or drop off at 3200 Cedar Street 2nd Floor Drop Box CONTACT INFORMATION: (P)425-257-8810 1(E)PermitServices@everettwa.gov I(W)everettwa.gov/permits WASHINGTON PROJECT SITE INFORMATION PROJECT ADDRESS:113 75th ST SW Everett,WA 98203 1 PARCEL#:00792400003200 BUILDING TYPE: ✓❑SFR-DETACHED ❑SFR-ATTACHED/TOWNHOUSE ❑DUPLEX CONTACT INFORMATION OWNER NAME:William Wood CONTRACTOR NAME:Switch Electric CONTRACTOR LIC.#(REQUIRED): SWITCEL91OPK CITY OF EVERETT BUSINESS LIC.#(REQUIRED): 052557 PRIMARY CONTACT: ❑OWNER ❑✓ CONTRACTOR [-]OTHER(Please Specify) CONTACT NAME: I CONTACT PHONE:425-220-5042 Lanae Viruet ICONTACT EMAIL:Lanae@myswitchelectric.com SOLAR PANEL APPLICATION INFORMATION PV SYSTEM DESCRIPTION (include manufacturer and model,#of PV modules and inverters): Install 10.25 kW solar array with REC panels and Enphase Micro Inverters and 20 kW storage with Enphase Batteries BUILDING PERMIT CHECKLIST DETERMINE IF YOUR PROJECT QUALIFIES FOR AN OVER-THE-COUNTER BUILDING PERMIT: If you answer yes to all of the below questions, the project qualifies for an over-the-counter building permit. YES NO 1. PV system is designed and proposed for a detached one-or two-family dwelling or townhouse not more than three stories above grade or detached accessory structure that is code compliant to setbacks and height, or code allows ❑✓ ❑ expansion of nonconformity for solar modules. [IRC 101.2] 2. Modules on pitched roofs do not exceed the highest point of the roof unless approved by the local jurisdition. ✓❑ ❑ 3. Rooftop is made from lightweight material such as a single layer of composition shingles, metal roofing, lightweight ❑ ❑ masonry, or cedar shingles. 4. The installation shall comply with the manufacturer's instructions. [IRC M2302.2] ❑✓ ❑ 5. The installation shall meet the requirements of NFPA 70 National Electric Code, and all required electrical permit(s) must ❑ ❑ be obtained from the Authority having Jurisdiction to administer the electrical code. [IRC M2302.2] 6. The installation shall meet the requiremetns of the International Fire Code as amended by WA State. [IRC M2302.2] ❑✓ ❑ 7. The PV system is designed for the wind speed of the local area, and will be installed per the manufacturer's ❑ ❑ specifications. [IRC M2302.2.1(1)] 8. The ground snow load does not exceed 70 pounds per square foot. [IRC M2302.2.1(1)] ❑ 9. The total dead load of modules, supports, mountings, raceways, and all other appurtenances weigh no more than four El per square foot. [IRC M2302.2.1(3)]. Enter total dead load of system (lbs/sq.ft.):2.45 10. To address uplift, modules are mounted no higher than 18" above the surface of the roofing to which they are affixed. ❑✓ ❑ [IRC M2302.2.1(4)] 11. Supports for solar modules are installed to spread the dead load across as many roof-framing members as needed to ❑✓ ❑ ensure that no point load exceeds fifty(50) pounds. [IRC M2302.2.1(5)] 12. The photovoltaic modules and supporting structure shall be constructed of noncombustible materials or fire-retardant ❑ ❑ treated wood equivalent to that required for the roof construction. [IRC M2302.2.1] 13. Roof and wall penetrations shall be flashed and sealed to prevent entry of water, rodents, and insects. [IRC M2302.2.21 ❑✓ ❑ 14. PV modules are listed and laveled with a fire classification in accordance with UL 1703. [IRC M2302.2.3] ❑✓ ❑ Comments: PLEASE FILL OUT A CITY OF EVERETT BUILDING PERMIT APPLICATION IF YOU QUALIFY FOR AN OTC BUILDING PERMIT. City of Everett Official Use Only ASSSSOCIATED BUILDING PERMIT# Continue on to Page 2 of Application (Revised 4/21/2022)