2420 38TH ST ROYELL MANUFACTURING 2025-03-27

Mounting Height Requirements : WARNING O If touched,the vent pipe and internal heater surfaces that are accessible from outside the heater will cause burns.Suspend the heater a minimum of 5 feet (1.5 meters) above the floor. • For best results,the heater should be mounted with certain rules In mind. In general, a unit should be located 8 to 12 feet(2.4 to 3.7 meters) above the floor. Units should always be arranged to blow toward or along exposed wall surfaces, if possible.Where two or more units are installed in the same room, a general scheme of air circulation should be maintained for best results. • Suspended heaters are most effective when located as close to the working zone as possible,and this fact should be kept in mind when determining the mounting heights to be used. However, care should be exercised to avoid directing the discharged air directly on the room occupants. • Partitions,columns,counters,or other obstructions should betaken into consideration when locating the unit heater so that a minimum quantity of airflow will be deflected by such obstacles. • When units are located in the center of the space to be heated,the air should be discharged toward the exposed walls. In large areas, units should be located to discharge air along exposed walls with extra units provided to discharge air in toward the center of the area. • At those points where infiltration of cold air is excessive, such as at entrance doors and shipping doors, it is desirable to locate the unit so that it will discharge directly toward the source of cold air from a distance of 15 to 20 feet (4.6 to 6.1 meters). • For a location where dirt,dust,or other airborne contaminants are present in the indoor environment,a separated- combustion unit that uses outside air for combustion is recommended. Using a separated-combustion unit reduces the buildup of contaminants on the burner. Any buildup on the burner adversely affects the combustion process. Hazards of Chlorine The presence of chlorine vapors in the combustion air of gas-fired heating equipment presents a potential corrosion hazard for separated-combustion heaters with regard to the combustion air inlet.Chlorine is usually found in the form of freon or degreaser vapors, When chlorine is exposed to flame, it will precipitate from the compound and go Into solution with any condensation that is present in the heat exchanger or associated parts.The result is hydrochloric acid, which readily attacks all metals including 300 grade stainless steel. Care should be taken to separate these vapors from the combustion process.This may be done by wise location of the unit vent and combustion air terminals with regard to exhausters or prevailing wind directions. Chlorine is heavier than air. Keep these facts In mind when determining installation location of the heater in relation to building exhaust systems. Dimensions Unit dimensions are shown in Figure 2 and Figure 3 and listed in Table 4 and Table 5. 1-UBX-UBZ-UDX-UDZ(04-21)1034344-0 7